Rechercher

Note: In order to maintain a consistent relationship between Clause numbers and subject matter throughout this Standard, some numbers may have been omitted. 1. Scope 1.1 This Standard applies to panelboards and enclosed panelboards, rated 600 V and less, for use in nonhazardous locations in accordance with the Rules of the Canadian Electrical Code, Part I, to provide overcurrent…

1. PURPOSE AND SCOPE 1.1 This standard describes a physical method of quantitative analysis. The method may be used to analyze mixtures of fibres that differ in density by at least 0.15 g/mL. The method may also be used when chemical methods of analysis are not suitable. The solvents used must not change the density of fibres. 1.2 The accuracy of the method depends upon sufficient difference…

This standard applies to four types of hemp cordage.

Gives methods of measurement for television broadcast receivers under conditions in which the signal presented to the receiver is not in accordance with the specifications for broadcast signals adopted by the CCIR. Such nonstandard signals may be produced by video tape recorders, video disc players and television games, among other sources. Specifies methods of measurement for those…

Specification of a method for determining an apparent viscosity of resins in a liquid state, using one of the types of rotational viskosimeter described in this standard. A spindle or disc is driven at constant rotational frequency in the product being studied. The resistance exerted by the fluid on the spindle, which depends on the viscosity of the product, cause a torque, which is indicated by…

1. Scope 1.1 This Standard covers the performance, construction, testing, marking, installation, operation, and servicing of complete commercial/industrial pressure washers and steam cleaners that are either gas-fired or oil-fired. 1.2 The Standard applies to (a) complete machines comprising a continuous coil-type heating system, with no space for steam accumulation, in which the…

1. Scope 1.1 This Standard covers welding requirements for any type of welded steel construction with the exception of those types listed in Clause 1.2. Requirements that are essentially common to all such structures are covered in Clauses 1 to 10, while provisions applying specifically to statically loaded structures and to dynamically loaded structures are included in Clauses 11 and…

1. Scope 1.1 This Standard covers welding requirements for any type of welded steel construction with the exception of those types listed in Clause 1.2. Requirements that are essentially common to all such structures are covered in Clauses 1 to 10, while provisions applying specifically to statically loaded structures and to dynamically loaded structures are included in Clauses 11 and…

Specifies the technical requirements for the design and construction of compressors; it also details the documetation requirements. Annex A, which contains instructions subject agreements in the contract, is given for information only. Annex B, which contains the data sheets, forms an integral part of this Standard.

Specifies details for types of threads and thread sizes. Tabulates nominal diameters from 9,73 mm up to and including 30 mm together with the corresponding pitches and designations, refers to the national standards of concern (table 1). Table 2 contains valve outlets for toxic gases; valve outlets for flammable gases are given in table 3. Table 4 gives valve outlets for oxidizing gases, and table…