Information Processing Systems - Data Communications - Use of the X.25 Packet Level Protocol in Loc...
This National Standard of Canada is equivalent to International Standard ISO/IEC 8881-1989.
1 Scope
This International Standard deals with the use of the X.25 Packet Level Protocol (PLP) as specified in ISO 8208 operating over ISO 8802 Local Area Networks (LANs). Section 2 of this International Standard specifies the operation of the X.25/PLP using the Logical Link Control (LLC) Type 2…
This Standard describes requirements and test methods for materials,
dimensions, workmanship, pipe stiffness, quality control, joining systems, and
marking for SDR 28, 35, and 41 Type PSM PVC sewer pipe and fittings.
Note: Industrial waste disposal lines should be installed only with specific
approval of the regulatory authority, since chemicals not commonly found in
drains and sewers and…
Surface acoustic wave (SAW) resonators - Part 1: General information, standard values and test condi...
Relates to surface acoustic wave (SAW) resonators for oscillator use. Provides general information and methods concerning measurements and tests common to many types of SAW resonators. Establishes uniform conditions for assessing the mechanical, electrical and climatic properties of SAW resonators, describes test methods, gives recommendations for standard values and gives guidance on SAW…
Establishes a specification of four types of aminoplastic moulding materials classified according to the intended application: Type UF A - general purpose Type MF B - Hot water resistant Type MF C - Thermal resistant and electrical Type MF D - Impact resistant These types have been further subdivided into grades based on property levels and requirements. The property requirements of 9 grades of…
1. Scope
1.1 This Standard, except as noted in Clause 1.2, applies to all liquid-filled transformers, autotransformers, booster transformers, load-tap-changing transformers, grounding transformers, phase-shifting transformers, series-voltage regulators, and shunt reactors.
Notes:
(1) The term transformer(s) in this Standard refers to the overall unit and not just to the electrical…
1. Scope
1.1 This standard applies to interior semigloss latex paint suitable for
use on all types of wall surfaces, either new or previously painted.
1.2 For more detailed information on intended uses see par. 7.2.
1.3 This standard may require the use of materials and/or equipment that
could be hazardous. This document does not purport to address all the…
1. SCOPe
1.1 This standard applies to four types of bleached cotton cheesecloth for
general office use.
1.2 This standard may require the use of materials and/or equipment that could
be hazardous. This document does not purport to address all the safety aspects
associated with its use. Anyone using this standard has the responsibility to
consult the appropriate authorities and to…
This standard applies to high-flash type aviation turbine fuel consisting
entirely of hydrocarbon compounds, except as otherwise specified. This is a
Military Grade Fuel and as such, product quality parameters are influenced by
International Military Standardization Agreements.
1. Scope
1.1 This Standard applies to oil burners of the atomizing-type, irrespective of size, firing rate, or grade
of fuel oil, that are designed primarily for installation in warm-air, hot-water, and steam-heating equipment.
As classified in CSA Standard B140.0, General Requirements for Oil Burning Equipment.
1.2 The requirements given herein do not apply to complete oil- fired…
Standard for Alarm Initiating and Supervisory Devices for Water Type Extinguishing Systems
Contains requirements for Alarm Initiating and Supervisory
Detection Devices for attachment to water type extinguishing
systems as follows:
A) Alarm Initiating Devices, including but not limited to:
(i) Vane and paddle type waterflow switches; and
(ii) Pressure actuated waterflow switches;
B) Supervisory Indicating Devices, including but not limited to:
(i)…
