Rechercher

This standard deals with flexible insulating sleeving with extruded PVC sleeving: -sheet 100: general purpose grade, -sheet 101: high temperature grade, -sheet 102: low temperature grade, -sheet 103: general purpose grade, unilateral tolerances, -sheet 104: high temperature grade, unilateral tolerances, -sheet 105: low temperature grade, unilateral tolerances.

Describes the method for the determination of the depth of indentation of an indentor under a specified force into the surface of rubber. This depth does not correspond with hardness as measured in accordance with ISO 48, ISO 1400 and ISO 1818. The Pusey and Jones indentation value is an inverse measurements of hardness, i.e. the harder the rubber the lower the Pusey and Jones indentation value.…

Lays down the data needed for the prefabrication and assembly of pipework and for its transfer from engineering departments to the workshops. Generation, type of presentation and filing organization of this data is not covered. Types of information are information on standard parts, information on non-standard parts and administrative information.

1.1 Scope 1.1.1 This Standard applies to manual lever operated, pressure lubricated, straight way gas shut-off valves of metallic construction with weld and flanged and threaded ends. 1.1.2 This Standard applies to valves used in: (a) appliances and equipment where gas is to be used for fuel purposes and, (b) piping and tubing systems falling within the pressure limitations…

1.1 Scope 1.1.1 This standard applies to newly produced manually operated shut-off valves for gas piping systems and constructed of entir ely new, unused parts and materials which: (a) are intended for use downstream of the distributors meter or regulator, for operation at a maximum pressure of 1/2 psig (3.4 kPa), (b) are capable of operation at ambient temperatures between 32°F (0°C) and…

1. SCOPe 1.1 This standard applies to unpigmented sealer intended primarily for use on resilient and nonresilient floors other than those of wood or cork. 1.2 Intended Uses - The sealers to this standard are intended for use in sealing resilient and nonresilient surfaces prior to the use of maintenance finishes. Type 1 solvent-based sealer should be used…

Applies to personal flotation devices (PFDs) intended for constant wear to increase the safety of adults (persons with a body mass greater than 41 kg) in situations where a risk of drowning exists. This standard covers devices that are inherently buoyant (Type I) and those with combined buoyancy (Type II).

1.1 This standard applies to manual drafting practices used in the preparation of all types of drawings for which microfilming is anticipated. 1.2 For computer aided drafting (CAD) practices, refer to CSA Standard B78.5, Computer Aided Drafting (Construction), (in preparation).

1. Scope 1.1 This Standard applies to dry type, air-cooled transformers, autotransformers (fixed and variable), and primary-circuit reactors intended for use in, on, or associated with other approved equipment in capacities of 1000 kV·A and less and for primary voltages of 750 V or less, 60 Hz and less, and intended for use in nonhazardous locations in accordance with the Canadian…

1. Scope 1.1 This Standard applies to ac and dc motors with inherent overheating protection designed to be used in accordance with the Rules of the Canadian Electrical Code, Part I, as follows: (a) motors with a voltage rating not exceeding 600 V and with a protective device connected in the motor circuits; (b) impedance protected motors with a voltage rating not exceeding 600 V; and (c…