Rechercher

Applies to the design of highway bridges that have spans up to l00 m, and is based upon the limit states design theory. It sets forth minimum requirements that are consistent with current practice. Modifications may be necessary in order to adapt the Standard for use in the design of a specific bridge, unusual types of bridges, and bridges with spans longer than 100 m.

1.1 This standard applies to a soft film type of solvent-dispersed rust preventive compound with water displacing properties. 1.2 For details on uses see par. 7.1.

This standard applies to the following types of reactors: shunt reactors, current-limiting reactors including neutral-earthing reactors, damping reactors, tuning (filter) reactors, earthing transformers (neutral couplers), arc-suppression reactors, smoothing reactors, with the exception of the following reactors: small reactors with a rating generally less than 2 kvar single-phase and 10 kvar…

This standard applies to solvent coated plastic film type carbon sheets for use in manual and electric typewriters.

1. Scope 1.1 This Standard applies to devices designed for installation on road motor vehicles to provide a daytime running light function where the vehicle is not factory-equipped with a daytime running light system. Note: This Standard has been harmonized as far as practicable with the applicable Canadian Motor Vehicle Safety Regulations. 1.2 This Standard covers the minimum…

Specifies test requirements for power cables for fixed installations with extruded insulation of the types listed in Sub-clause 1.4 for rated voltages, U, above 30 kV (Um = 36 kV) up to and including 150 kV (Um = 170 kV). The requirements apply to cables for usual conditions of installation and operation, but not to special cables, such as submarine cables, for which modifications to the standard…

Applicable to any type of building material that, by its own structural qualities or the manner in which it is applied, is capable of supporting itself in position or may be supported in the test furnace to a thickness comparable to its recommended use.

This Technical Report type 3 describes a methodology for determining whether a programming language processor possesses the required characteristics stated in the International Standard for the particular programming language for which it is intended.

This standard applies to two types of belached or dyed polyester/cotton pillow cases. These products are not recommended for use in hospital operating rooms.

This Technical Report type 3 describes a methodology for determining whether a programming language processor possesses the required characteristics stated in the International Standard for the particular programming language for which it is intended.