1. Scope
1.1
This Standard pertains to OSB panels intended for use in engineered design
applications and covers three types of Design Rated OSB panels: Type 1
(STANDARD), Type 2 (PLUS), and Type 3 (PROPRIETARY).
1.2
This Standard includes requirement for binders used in OSB manufacture.
1.3
This Standard specifies the method for evaluating short term basic structural
capacities of…
Automotive Adaptive Driving Controls (AADC) for Persons with Physical Disabilities
1. Scope
1.1 General
1.1.1 This Standard specifies performance requirements for all types of automotive adaptive driving control (AADC) systems, including those commonly known as quick-release and portable hand controls. These controls allow persons with physical disabilities to drive vehicles. It also specifies design, construction, and installation requirements and tests to be carried…
1. Scope
1.1 This Standard specifies the requirements for a material consisting of
alkaline salts and chlorine- or nonchlorine- bearing compounds suitable
for use in mechanical dishwashing equipment.
1.2 Material produced in accordance with this standard is intended for use
in mechanical dishwashing machines with soft or hard water. The
material is…
1. Scope
1.1 This standard applies to high-flash type aviation turbine fuel consisting entirely of hydrocarbon compounds, unless otherwise specified.
1.2 This standard describes a military grade fuel normally used in naval operations whose product quality parameters are influenced by international Military Standardization Agreements.
1.3 The testing and evaluation of a product against…
Construction and Test of Electric Storage-Tank Water Heaters
1. Scope
1.1
This Standard applies to both cord-connected and permanently connected
storage-tank water heaters*, having tanks less than 610 mm inside diameter, for
use on nominal system voltages of 600 V and less, and designed to be used in
nonhazardous household and commercial locations in accordance with the Rules
of the Canadian Electrical Code, Part I.
*For convenience only, the…
1. Scope and Application
1.1
This Standard provides rules and requirements for the design, fabrication, and
erection of steel structures. The design is based on limit states. The term
"steel structures" refers to structural members and frames that consist
primarily of structural steel components, including the detail parts, welds,
bolts, or other fasteners required in…
Information technology — Language independent arithmetic — Part 1: Integer and floating point arithm...
Defines integer and floating point data types (bounded, unbounded, and modulo integer types as well as normalized and denormalized floating point types) on computer systems and their properties to ensure that the processing of arithmetic data can be undertaken in a reliable and predictable manner. The requirements given shall be in addition to those that may be specified in other standards, e.g.…
Rubber compounding ingredients — Carbon black — Determination of specific surface area by nitrogen a...
Specifies four methods for the determination of the specific surface area of types and grades of carbon black for use in the rubber industry: method A using the Ni-Count-1 apparatus, method B using the Areameter apparatus, method C using gas chromatography, method D using the Monosorb surface-area analyser. Somewhat different results may be obtained from the four methods. The degassing procedure…
Information technology — International Standardized Profiles TB, TC, TD and TE — Connection-mode Tra...
Applicable to End Systems concerned with operating in the Open Systems Interconnection (OSI) environment. Specifies a combination of OSI standards, which collectively provide the connection-mode Transport Service using the connection-mode Network Service. Specifies subnetwork-type dependent requirements applicable to an end system attached to a local area network (LAN) subnetwork and using the…
Information technology - Language independent arithmetic - Part 1: Integer and floating point arithm...
Defines integer and floating point data types (bounded, unbounded, and modulo integer types as well as normalized and denormalized floating point types) on computer systems and their properties to ensure that the processing of arithmetic data can be undertaken in a reliable and predictable manner. The requirements given shall be in addition to those that may be specified in other standards, e.g.…
