Rechercher

1. Scope 1.1 General This Standard describes the apparatus, test methods, and formulas to be used in carrying out the tests and calculations required by CSA electrical wire and cable Standards. 1.2 Acceptance Requirements The acceptance requirements expected to be fulfilled through the testing of any particular type of wire or cable are contained in the Standard relating to…

1. Scope 1.1 This Standard applies to self-propelled integral chassis elevated work platforms that have a platform that cannot be positioned completely beyond the base and that are used to position personnel, along with their necessary tools and materials, at work locations. Self-propelled elevating work platforms(aerial platforms) are power operated with primary functions, including drive,…

This National Standard of Canada is equivalent to International Standard ISO 3767-1:1998. 1 Scope This part of ISO 3767 establishes the common symbols for use on operator controls and other displays on tractors and machinery for agriculture and forestry, and powered lawn and garden equipment as defined in ISO 3339-0 and ISO 5395. The symbols given apply to controls and displays…

This National Standard of Canada is based on International Standard CEI/IEC 335-2-34: 1999 (third edition, 1999-10). 1 Scope This clause of part 1 is replaced by the following. This standard deals with the safety of sealed (hermetic and semi-hermetic type) motor-compressors, their protection and control systems, if any, which are intended for use in equipment for household and similar…

Provides general principles and detailed requirements for the design and formulation of all types of instructions that will be necessary or helpful for document kinds to accompany products ranging from small, simple ones, such as tin of paint, to large or highly complex ones, such as a large industrial installation. If the paper version of this standard is ordered, a diskette is provided with…

This International Standard specifies overall fixing dimensions of wristwatch-cases to which bracelets or straps are fastened by means of a set of fixing pins and tubes. This International Standard is applicable to wristwatch-cases with four or with two lugs.

Requirements are applicable to mobile or transportable units. For the purpose of this standard, the term 'unit' is intended to mean a vehicle and/or mobile or transportable structure in which all or part of an electrical installation is contained. Units are : - either of the mobile type, e.g. vehicles (self-propelled or towed); - or of the transportable type,e.g. containers or cabins…

This International Standard specifies the physical and magnetic characteristics of an 8 mm wide magnetic tape cartridge containing a memory chip to enable physical interchange of such cartridges between drives. It also specifies the quality of the recorded signals, the recording method and the recorded format - called Advanced Intelligent Tape No.2 with Memory In Cartridge (AIT-2 with MIC) -…

This International Standard specifies the physical and magnetic characteristics of an 8 mm wide magnetic tape cartridge containing a memory chip to enable physical interchange of such cartridges between drives. It also specifies the quality of the recorded signals, the recording method and the recorded format - called Advanced Intelligent Tape No.2 with Memory In Cartridge (AIT-2 with MIC) -…

This National Standard of Canada is equivalent to International Standard ISO/IEC ISP 10613-7:1994. 1 Scope This International Standardized Profile is applicable to interworking units concerned with operating in the Open Systems Interconnection (OSI) environment. It specifies a combination of OSI base standards that collectively provide a Network Relay function for the connectionless-mode…