Rechercher

This International Standard specifies the physical and magnetic characteristics of an 8 mm wide magnetic tape cartridge to enable physical interchange of such cartridges between drives. It also specifies the quality of the recorded signals, the recording method and the recorded format called VXA-1, and thereby allowing data interchange between drives by means of such magnetic tape cartridges.…

Applies to the specification of performance, with primary reference to industrial applications, of the following kinds of electrical and electronic equipment: - indicating and recording instruments which measure electrical quantities; - material measures which supply electrical quantities; - instruments which measure non-electrical quantities using electrical means, for all parts of the measuring…

Reference software is normative in the sense that any conforming implementation of the software, taking the same conformant bitstreams, using the same output file format, will output the same file. Complying ISO/IEC 14496 implementations are not expected to follow the algorithms or the programming techniques used by the reference software. Although the decoding software is considered normative,…

Reference software is normative in the sense that any conforming implementation of the software, taking the same conformant bitstreams, using the same output file format, will output the same file. Complying ISO/IEC 14496 implementations are not expected to follow the algorithms or the programming techniques used by the reference software. Although the decoding software is considered normative,…

This International Standard specifies requirements for fine-tolerance hoist chain of Grade T (types T, DAT and DT) for use with manually operated or power-driven chain hoists1). It is applicable to electrically welded, round, steel short-link chain, heat-treated and tested in accordance with the general conditions of acceptance of ISO 1834, in the nominal chain size range from 3 mm to 22 mm. NOTE…

This International Standard specifies the general requirements for the construction as well as the performance of type tests of magnetic compasses on board small craft of hull length up to 24 m. It refers to liquid magnetic compasses, which can be inspected (e.g. not sealed), either equipped with a direct reading system, or of the reflecting/projecting type. This International Standard also…

1 Scope 1.1 This Standard applies to motor-operated vacuum cleaners and blower cleaners, and to household use floor finishing machines to be employed in accordance with the Canadian Electrical Code Part I (CEC), and the National Electrical Code (NEC), ANSI/NFPA 70. 1.2 These requirements cover: a) household, commercial, and coin-operated vacuum cleaning machines and blower…

IEC 61754-18:2001 defines the standard interface dimensions for the type MT-RJ family of connectors. Keywords: type MT-RJ family of connectors

This International Standard specifies the characteristics of a 300 mm optical disk cartridge (ODC) of Type WORM (Write Once Read Many) using irreversible effects, with a capacity of 30 Gbytes. This WORM ODC's uses writing effects that are inherently irreversible. Written marks cannot be erased and attempted modifications of the written marks are detectable. This International Standard…

This International Standard specifies the characteristics of a 300 mm optical disk cartridge (ODC) of Type WORM (Write Once Read Many) using irreversible effects, with a capacity of 30 Gbytes. This WORM ODC's uses writing effects that are inherently irreversible. Written marks cannot be erased and attempted modifications of the written marks are detectable. This International Standard…