Rechercher

Defines the standard interface dimensions for the type SG family of connectors.

This International Standard specifies a method for the determination of the ash content of petroleum products, such as distillate and residual fuel oils, crude petroleum, lubricating oils, waxes and other petroleum products, in which any ash-forming constituents present are normally considered to be undesirable impurities or contaminants. Ash can result from oil-soluble or water-soluble metallic…

This International Standard specifies test methods and minimum performance requirements for protective clothing that relies upon the ability of the outer material to reflect intense radiant heat. The clothing covered by this International Standard is intended to provide protection against flame lick and intense radiant heat and it should be worn for short periods only. Subject to a risk…

La présente partie de l'ISO 5267 spécifie une méthode de détermination de l'égouttabilité, en termes d'indice d'égouttage «Canadian Standard» (CSF) exprimé en millilitres, d'une suspension aqueuse de pâte. En principe, cette méthode est applicable à tous les types de pâtes en suspension aqueuse. NOTE Les traitements produisant une grande quantité de fines peuvent…

La présente Norme internationale établit une convention pour l'identification des dimensions de montage et des modes de fixation des vérins pour transmissions hydrauliques et pneumatiques. En particulier, elle spécifie un code pour identifier les dimensions de fixation, d'encombrement, d'accessoires et de raccord du vérin, et d'un code pour identifier les types d'…

This International Standard specifies test methods and minimum requirements for protective gloves to be worn during fire fighting and associated activities where there is a risk of heat and/or flame. The purpose of this International Standard is to provide minimum performance requirements for protective gloves designed to protect against injury in fire fighting operations. This International…

This International Standard specifies dimensions for lubrication holes, grooves and pockets for bearing bushes. These dimensions can be entered, e.g. on drawings, using the designation examples. Their use depends in particular on the specific operating conditions. In addition, it enables the user to assign the different types of lubricant feed and distribution to plain bearing bushes made of…

1.1 SCOPE 1.1.1 This standard applies to newly produced type 2 clothes dryers (see Part IV, Definitions) hereinafter referred to as dryers, constructed entirely of new, unused parts and materials: a. For use with natural gas; b. For use with manufactured gas; c. For use with mixed gas; d. For use with propane gas; e. For use with liquefied petroleum gases; and f. For use with LP gas-…

1. Scope 1.1 This Standard provides criteria for the aspects of HVAC systems that are particular to health care facilities. These criteria lead to more stringent requirements that are above and beyond those generally applied in planning, designing, constructing, commissioning, maintaining, and operating HVAc systems. 1.2 This Standard sets values of certain parameters, identifies…

1. Scope 1.1 This Standard applies to ac and dc type power supplies, including rack-mounted and modular units, that (a) are of dry or liquid-filled construction; (b) have a rated voltage not exceeding 600 V; and (c) are for commercial, industrial, and residential indoor and outdoor use in nonhazardous locations in accordance with the Rules of the Canadian Electrical Code, Part I. Note:…