Rechercher

This National Standard of Canada is equivalent to International Standard ISO/IEC 11581-3:2000. 1 Scope ISO/IEC 11581 applies to icons that are shown on a screen, that users can manipulate and interact with, and that represent data or computer system functions. This part of ISO/IEC 11581 addresses only pointer icons. Pointers are icons that are logically attached to a physical input device,…

This National Standard of Canada is equivalent to International Standard ISO/IEC 13961:2000/IEEE 1596, 1998. 1.2.1 Scope and directions Purpose: To define an interface standard for very high-performance multiprocessor systems that supports a coherent shared-memory model scalable to systems with up to 64 K nodes. This standard is to facilitate assembly of processor, memory, I/O, and bus…

This National Standard of Canada is equivalent to International Standard ISO/IEC 14769:2001. 1 Scope The concept of "type" is fundamental to ODP systems; the interaction model of ODP-RM involves strongly-typed interactions. This Recommendation | International Standard: . defines a framework for describing types of interest in ODP systems by determining what entities need to be…

This part of ISO/IEC 9318 describes the logical level (generic level) interface for tape drives and it provides a definition of the device-generic portion of a family of standards called the Intelligent Peripheral Interface (IPI). The purpose of this standard is to facilitate the development and utilization of an intelligent interface which permits the interconnection of multiple peripheral types…

ISO 15705:2002 specifies a method for the determination of the chemical oxygen demand (ST-COD) using the sealed tube method. The test is empirical and is applicable to any aqueous sample, which includes all sewage and waste waters. The method is applicable to undiluted samples having ST-COD values up to 1 000 mg/l and a chloride concentration not exceeding 1 000 mg/l. Samples with higher ST-COD…

ISO 14966:2002 specifies a method using scanning electron microscopy for determination of the concentration of inorganic fibrous particles in the air. The method specifies the use of gold-coated, capillary-pore, track-etched membrane filters, through which a known volume of air has been drawn. Using energy-dispersive X-ray analysis, the method can discriminate between fibres with compositions…

ISO 7314 gives specifications for medium pressure, high temperature, flexible metal hose assemblies suitable for continuous operation in liquid and pneumatic systems from - 55 °C to + 400 °C, with short duration excursions up to + 650 °C. The hose assemblies covered by this International Standard are intended for use in aerospace applications for conveying air and other gases in pneumatic systems…

ISO 15797 specifies test procedures and equipment which can be used in the evaluation of cotton, polyester/cotton and reverse blend workwear intended to be industrially laundered. They serve as a basis for testing relevant properties such as dimensional stability, colour fastness, creasing and seam puckering. This International Standard does not provide instructions and specifications for the…

ISO 6577 specifies requirements for nutmeg, whole or broken, and for mace, whole or in pieces, obtained from the nutmeg tree (Myristica flagrans Houtt.) for wholesale commercial purposes. NOTE As nutmeg and mace are obtained from the same plant, it was considered preferable to give the specifications for these two spices in one International Standard. It does not apply to Papua-type nutmeg and…

1. SCOPE 1.1 This standard applies to two types (type 11 and type 15) of naval distillate fuel for marine (naval) applications such as gas turbine power plants, high-and medium-speed internal combustion engines of the compression-ignition type, and boilers. Fuel produced to this standard is not intended for use in aircraft turbine engines. 1.2 Type 11 is intended for equipment operating…