Rechercher

ISO/IEC 17345:2005 specifies the mechanical, physical and optical characteristics of a 130 mm optical disk cartridge (ODC) that employs thermo-optical Phase Change effects to enable data interchange between such disks. ISO/IEC 17345:2005 specifies two types: Type RW (rewritable) provides for data to be written read and erased many times over the recording surfaces of the disk.Type WORM (write…

ISO/IEC 17345:2005 specifies the mechanical, physical and optical characteristics of a 130 mm optical disk cartridge (ODC) that employs thermo-optical Phase Change effects to enable data interchange between such disks. ISO/IEC 17345:2005 specifies two types: Type RW (rewritable) provides for data to be written read and erased many times over the recording surfaces of the disk.Type WORM (write…

Scope 1.1.1 This Standard covers CGA 791 (Type I) and CGA 810 (Type II) cylinder connection devices, as defined in Part IV, Definitions, intended to connect the cylinder valve on portable LP-Gas containers to the inlet of the regulator on outdoor cooking gas appliances. These cylinder connection devices are intended for vapour withdrawal service only. 1.1.2 The cylinder connection devices…

This National Standard of Canada is equivalent to International Standard ISO/TS 17090-1:2002. 1 Scope This part of ISO/TS 17090 defines the basic concepts of a healthcare public key infrastructure (PKI) and provides a scheme of interoperability requirements to establish a PKI enabled secure communication of health information. It also identifies the major stakeholders who are…

1 Scope 1.1 This Standard applies to protective headwear for industrial, construction, mining, utility, and forestry workers. It defines the areas of the head that are to be protected and includes basic performance requirements for dielectric strength, impact attenuation, penetration resistance, passive retention (stability), and shell flammability and liner ignition resistance. 1.2 This…

1 Scope 1.1 This Standard specifies requirements for the performance, design, testing, marking, and instructions of body belts and saddles. Body belts and saddles are used as part of work positioning and travel restraint systems. 1.2 This Standard covers equipment such as (a) lineman.s body belts; (b) body belts; (c) miners. belts; and (d) arborists. saddles. 1.3 This Standard does…

1 Scope 1.1 This Standard specifies requirements for Type NS75 and NS90 neutral supported cables for use on outdoor overhead electrical systems that have nominal voltages of 600 V or less for installation in accordance with the Canadian Electrical Code, Part I. 1.2 Neutral supported cables covered by this Standard consist of up to five conductors (one, two, or three insulated phase…

This National Standard of Canada is equivalent to International Standard ISO 12117:1997. 1 Scope This International Standard establishes a consistent and reproducible means of evaluating the load-carrying characteristics of tip-over protective structures (TOPS) under static loading, and prescribes performance requirements of a representative specimen under such loading. It applies to TOPS…

This National Standard of Canada is equivalent to International Standard ISO 1996-1:2003. 1 Scope This part of ISO 1996 defines the basic quantities to be used for the description of noise in community environments and describes basic assessment procedures. It also specifies methods to assess environmental noise and gives guidance on predicting the potential annoyance response of a community to…

1 Domaine d'application 1.1 Cette norme vise trois types de membranes d'étanchéité bitumées et à base de fibres de verre (matériaux de couverture en rouleaux imprégnés ou enduits de bitume à base de fibres de verre) et recouverts d'une matière minérale insoluble: a) Type I: une membrane légère destinée à être utilisée principalement comme couche de pose pour bardeaux. b) Type…