Rechercher

ISO 13501:2005 provides a standard procedure for assessing and modifying performance of solids control equipment systems commonly used in the field in petroleum and natural gas drilling fluids processing. ISO 13501:2005 is not intended for the comparison of similar types of individual pieces of equipment.

IEC 60684-3-212:2005 standard gives the requirements for four types of heat-shrinkable polyolefin sleevings suitable for use at temperatures up to 135 °C.<br /> Type A: flame retarded, shrink ratio 2:1,<br /> Type B: not flame retarded, shrink ratio 2:1,<br /> Type C: flame retarded, shrink ratio 3:1,<br /> Type D: not flame retarded shrink ratio 3:1. This second edition…

This standard gives the requirements for two types of heat-shrinkable, not flame retarded, polyolefin sleeving with a nominal shrink ratio of 3:1 and with thick and medium wall. This sleeving has been found suitable at temperatures up to 135 °C. - Type A: Medium wall - internal diameter of upt to 180,0 mm. - Type B: Thick wall - internal diameter of up to 160,0 mm.

IEC 60684-3-212:2005 standard gives the requirements for four types of heat-shrinkable polyolefin sleevings suitable for use at temperatures up to 135 °C. Type A: flame retarded, shrink ratio 2:1, Type B: not flame retarded, shrink ratio 2:1, Type C: flame retarded, shrink ratio 3:1, Type D: not flame retarded shrink ratio 3:1. This second edition cancels and replaces the first edition…

ISO 291:2005 sets out specifications relating to the conditioning and testing of all plastics and all types of test specimen at constant atmospheric conditions. Special atmospheres applicable to a particular test or material or simulating a particular climatic environment are not included.

ISO 10042:2005 specifies quality levels for imperfections in arc-welded joints in aluminium and its alloys. It applies to material thicknesses above 0,5 mm. It covers full-penetration butt welds and all fillet welds. The principles of the standard may also be applied to partial-penetration butt welds. Three quality levels are given in order to permit application to a wide range of welded…

ISO 13628-1:2005 provides general requirements and overall recommendations for development of complete subsea production systems, from the design phase to decommissioning and abandonment. ISO 13628-1:2005 is intended as an umbrella document to govern other parts of ISO 13628 dealing with more detailed requirements for the subsystems which typically form part of a subsea production system. However…

ISO/IEC 11693:2005 is one of a series of standards describing the parameters for optical memory cards and the use of such cards for the storage and interchange of digital data. It recognizes the existence of different methods for recording and reading information on optical memory cards, the characteristics of which are specific to the recording method employed. In general, these different…

ISO/IEC 11693:2005 is one of a series of standards describing the parameters for optical memory cards and the use of such cards for the storage and interchange of digital data. It recognizes the existence of different methods for recording and reading information on optical memory cards, the characteristics of which are specific to the recording method employed. In general, these different…

ISO 6966-1:2005 specifies the minimum general design requirements applicable to aircraft ground support equipment in order to ensure definition of aircraft ground support equipment general requirements for designers;effective operation of aircraft ground support equipment. The requirements of ISO 6966-1:2005 apply to any piece of aircraft ground support equipment used on airports. ISO 6966-1:2005…