Rechercher

IEC 62271-106:2011 is applicable to a.c. contactors and/or contactor-based controllers and motor-starters designed for indoor installation and operation at frequencies up to and including 60 Hz on systems having voltages above 1 000 V but not exceeding 24 000 V. It is applicable only to three-pole devices for use in three-phase systems, and single-pole devices for use in single-phase systems. Two…

ISO/IEC 27035:2011 provides a structured and planned approach to: detect, report and assess information security incidents; respond to and manage information security incidents; detect, assess and manage information security vulnerabilities; and continuously improve information security and incident management as a result of managing information security incidents and vulnerabilities. ISO/IEC…

ISO/IEC 27035:2011 provides a structured and planned approach to: detect, report and assess information security incidents; respond to and manage information security incidents; detect, assess and manage information security vulnerabilities; and continuously improve information security and incident management as a result of managing information security incidents and vulnerabilities. ISO/IEC…

ISO/TR 23697:2011 can be applied to textiles and textile products and is concerned only with test methods which operate in a continuous scale to yield a single numerical figure as the test result. However, this single figure can be the outcome of a calculation from a set of measurements. The distribution of test results is required to be unimodal and is assumed to be normal. With non-Gaussian…

ISO 2303:2011 specifies, for general-purpose non-oil-extended, solution-polymerized polyisoprene rubbers (IR): physical and chemical tests on raw rubbers; standard materials, a standard test formulation, equipment and processing methods for evaluating the vulcanization characteristics.

IEC 62271-1:2007+A1:2011 applies to a.c. switchgear and controlgear designed for indoor and outdoor installation and for operation at service frequencies up to and including 60 Hz on systems having voltages above 1 000 V. This standard applies to all high-voltage switchgear and controlgear except as otherwise specified in the relevant IEC standards for the particular type of switchgear and…

1. SCOPE 1.1 This standard applies to three types of middle distillate fuel oils that are suitable for use in liquid-fuel-burning equipment without preheating (Types 0, 1 and 2), and three types of fuel oils that contain residual fuel components and require preheating (Types 4, 5 and 6). 1.2 The heating fuel oils covered by this standard are intended for use in oil burning equipment to generate…

1.1 Scope 1.1.1 This standard applies to unvented portable type gas camp heaters of the infrared type only up to and including a maximum input of 12,000 Btu/hr (3 517 w) using propane, butane, and liquefied petroleum gases and mixtures thereof, and intended for outdoor use. 1.1.2 This standard applies to portable type gas camp heaters having: a. A regulated pressure; or b. A non-regulated…

1.1 Scope 1.1.1 This standard applies to portable type gas camp lights for use: a. With propane, butane, liquefied petroleum gas and any combination thereof; and b. Outdoors only. 1.1.2 Lights and components employing materials or having forms of construction differing from those detailed in these provisions may be examined and tested according to the intent of the provisions and if found to…

1.1 Scope 1.1.1 This standard applies to portable type gas camp stoves, having input ratings of 12,000 Btu/hr (3.5 kW) or less per burner for use: a. With propane, butane, liquefied petroleum gas, and any combination thereof; and b. Outdoors only. 1.1.2 Stoves and components employing materials or having forms of construction differing from those detailed in these provisions may be…