Rechercher

Affiner les résultats
Code de la Classification internationale pour les normes (ICS)
Source
Code de l’organisme d’élaboration de normes (OEN)
Langue
Statut
Code de la Norme nationale du Canada (NNC)
Date de publication

De

à

Affichage 2661 - 2670 de 6772
Automatic electrical controls — Part 1: General requirementsDispositifs de commande électrique autom...
1.1 Scope [Add the following paragraphs and note] The object of this Part 1 Standard is to specify general electrical safety requirements for certain products. The requirements of this Standard apply to a specific end-use product when it is explicitly referred to by that product standard. Each individual product standard may supplement, modify, or omit a general rule in the Part 1 Standard…
Éditeur :
CSA
Statut :
Norme
Date de publication :
2014-12-31
Code(s) de l'ICS :
97.120
Technical requirements for in-service evaluation of zirconium alloy pressure tubes in CANDU reactors
1.1 This Standard specifies the technical requirements for the owner/operator to ensure structural integrity of cold-worked Zr-2.5 wt% Nb alloy pressure tubes in operating CANDU reactors. Clause 13 of CSA N285.0/N285.6 Series requires that when in-service inspection results or material surveillance results do not satisfy the requirements of the original inspection program, a fitness-for-…
Éditeur :
CSA
Statut :
Norme
Date de publication :
2014-12-31
Code(s) de l'ICS :
27.120.10; 27.120.20
Heating fuel oil
1 Scope This standard applies to three types of middle distillate fuel oils that are suitable for use in liquid-fuel-burning equipment without preheating (Types 0, 1 and 2), and three types of fuel oils that contain residual fuel components and require preheating (Types 4, 5 and 6). The heating fuel oils covered by this standard are intended for use in oil burning equipment to generate heat for…
Éditeur :
ONGC
Statut :
Annulée
Date de publication :
2014-12-31
Code(s) de l'ICS :
75.160.20
Mechanical protection tubing (MPT) and fittings
1 Scope 1.1 This Standard applies to nonmetallic or composite mechanical protection tubing (MPT), and nonmetallic, composite or metallic fittings, and clamps used for the support, routing and mechanical protection of conductors, wires, and cables. The MPT, fittings, and clamps are intended to be used to interconnect separate component assemblies or consoles of electrical devices, such as…
Éditeur :
CSA
Statut :
Annulée
Date de publication :
2014-12-31
Code(s) de l'ICS :
01
Energy performance of stationary electric signs
1.1 This Standard specifies requirements and test procedures to determine the performance of stationary electric signs that are hard wired. Note: Background information on the scope and objective of this Standard is provided in Annex B. 1.2 This Standard applies to stationary electric signs for indoor or outdoor use, in nonhazardous locations, intended for installation in accordance with the…
Éditeur :
CSA
Statut :
Norme
Date de publication :
2014-12-31
Code(s) de l'ICS :
01
Panelboards and enclosed panelboards
1.1 This Standard applies to panelboards and enclosed panelboards, rated 600 V and less, for use in nonhazardous locations in accordance with the Canadian Electrical Code, Part I, to provide overcurrent protection for a number of circuits. 1.2 Clauses 1 to 6 apply to panelboards and enclosed panelboards of other than the service entrance type and apply, unless otherwise noted, to the…
Éditeur :
CSA
Statut :
Norme
Date de publication :
2014-12-31
Code(s) de l'ICS :
01
Non-recirculating direct gas-fired industrial air heaters
1.1 This Standard applies to newly produced, direct gas-fired industrial air heaters of the non-recirculating type, hereinafter referred to as heaters, whose purpose is to offset building heat loss. All air to the heater is ducted directly from outdoors and the products of combustion generated by the heater are released into the air stream being heated. Heaters covered by this Standard are…
Éditeur :
CSA
Statut :
Annulée
Date de publication :
2014-12-31
Code(s) de l'ICS :
01
Gas clothes dryers, volume I, type 1 clothes dryers
1.1 This Standard applies to newly produced Type 1 clothes dryers (see Clause 3, Definitions), hereinafter referred to as dryers, constructed entirely of new, unused parts and materials: a) for use with natural gas; b) for use with manufactured gas; c) for use with mixed gas; d) for use with propane gas; e) for use with LP gas-air mixtures; and f) for mobile home installation (see Clause 4.1.12…
Éditeur :
CSA
Statut :
Annulée
Date de publication :
2014-12-31
Code(s) de l'ICS :
01
Workplace electrical safety
1.1 General This Standard specifies requirements for workplace electrical safety necessary for the practical safeguarding of workers during activities such as the installation, inspection, operation, maintenance, and demolition of electric conductors and electric equipment, as well as work in proximity of energized electrical equipment. 1.2 Application While it can be applied by…
Éditeur :
CSA
Statut :
Annulée
Date de publication :
2014-12-31
Code(s) de l'ICS :
13.100; 13.260
Direct gas-fired process air heaters
1.1 This Standard applies to newly produced, direct gas-fired process air heaters of the recirculating or nonrecirculating type (see Clause 3, Definitions), hereinafter referred to as heaters, whose primary purpose is to provide process heating to non-occupied spaces within commercial and industrial buildings and may also include operation as a non-recirculating ventilation air heater (see Clause…
Éditeur :
CSA
Statut :
Annulée
Date de publication :
2014-12-31
Code(s) de l'ICS :
01

Spacer