Rechercher

This clause of Part 1 is replaced by the following. This International Standard deals with the safety of sealed (hermetic and semi-hermetic type) MOTORCOMPRESSORS, their protection and control systems, if any, which are intended for use in equipment for household and similar purposes and which conform with the standards applicable to such equipment. It applies to MOTOR-COMPRESSORS tested…

1.1 This Standard applies to single- and multi-conductor Type TECK 90 armoured cable intended for installation in accordance with the Canadian Electrical Code, Part I, on systems having nominal voltages of 5000 V and less and having a maximum temperature rating of 90 °C in both dry and wet locations. 1.2 In this Standard, “shall” is used to express a requirement, i.e., a provision that the…

CISPR TR 18-2:2017 RLV contains both the official IEC International Standard and its Redline version. The Redline version is available in English only and provides you with a quick and easy way to compare all the changes between the official IEC Standard and its previous edition. CISPR TR 18-2:2017 which is a Technical Report, applies to radio noise from overhead power lines and high-voltage…

CISPR TR 18-2:2017 which is a Technical Report, applies to radio noise from overhead power lines and high-voltage equipment which may cause interference to radio reception. The frequency range covered by this publication is 0,15 MHz to 3 GHz. A general procedure for establishing the limits of the radio noise field from the power lines and equipment is recommended, together with typical values as…

IEC TS 62950:2017(E) sets out a reference framework for defining and testing smart capabilities and smart operating modes of appliances, small scale energy supplies (SSESs) and other devices (ODs) (collectively termed 'smart devices' if they have the defined capabilities). This document does not set minimum requirements for appliances, SSESs or ODs. This document focuses on electricity…

IEC 60775:2017(E) provides general minimum requirements, recommendations and information for the drafting of standards on residual current operated protective devices (hereinafter referred to as residual current devices, "RCDs"). It applies to any device providing residual current protection intended primarily for protection against electric shock hazard. This first edition cancels and…

ISO 28590:2017 provides a general introduction to acceptance sampling by attributes and provides a brief summary of the attribute sampling schemes and plans used in ISO 2859‑1, ISO 2859‑2, ISO 2859‑3, ISO 2859‑4 and ISO 2859‑5, which describe specific types of attribute sampling systems. It also provides guidance on the selection of the appropriate inspection system for use in a particular…

IEC 61097-3:2017 specifies the performance requirements, technical characteristics, operational requirements and methods of testing of shipborne DSC equipment for use with MF, MF/HF and VHF installations in the GMDSS, including those required by Chapter IV of the 1974 International Convention for Safety of Life at Sea (SOLAS) as amended, and is associated with IEC 60945 (Shipborne radio equipment…

ISO 22007-1:2017 describes the background to methods for the determination of the thermal conductivity and thermal diffusivity of polymeric materials. Different techniques are available for these measurements and some may be better suited than others for a particular type, state and form of material. ISO 22007-1:2017 provides a broad overview of these techniques. Standards specific to these…

ISO 10639:2017 specifies the properties of piping system components made from glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP). It is suited for all types of water supply with or without pressure, including, but not limited to, raw water, irrigation, cooling water, potable water, salt water, sea water, penstocks in power plants, processing plants and other…