ISO 16228:2017 specifies the different types of fastener inspection documents issued by the fastener manufacturer or distributor and/or by the external authorized representative on specific request of the purchaser at the time of the order.
- declaration of compliance (F2.1);
- test reports (F2.2, F3.1 and F3.2).
NOTE The term "certificate" is in common use, however for…
Intelligent transport systems — Reference model architecture(s) for the ITS sector — Part 6: Use of ...
ISO 14813-6:2017 provides a formal means to achieve consistency in the use of ASN.1 when specifying data types that are to be used in ITS International Standards. This is designed to ensure unambiguous and interoperable data exchange while providing consistent documentation of these exchanges. This document provides the necessary specifications to ensure consistent interpretation by providing…
Electroacoustics - Audio-frequency induction loop systems for assisted hearing - Part 1: Methods of ...
IEC 62489-1:2010+A1:2014+A2:2017 applies to the components of audio-frequency induction-loop systems for assisted hearing. It may also be applied to such systems used for other purposes, as far as it is applicable. This standard is intended to encourage accurate and uniform presentation of manufacturers' specifications, which can be verified by standardized methods of measurement. It is…
Peintures et vernis — Anticorrosion des structures en acier par systèmes de peinture — Partie 2: Cla...
ISO 12944-2:2017 traite de la classification des principaux environnements auxquels sont exposées les structures en acier peintes et de la corrosivité de ces environnements. Le présent document
- définit les catégories de corrosivité atmosphérique, basées sur la perte de masse (ou la perte d'épaisseur) au moyen d'éprouvettes standard, et décrit les environnements atmosphériques…
Solid mineral fuels — Guidelines for the validation of alternative methods of analysis
ISO 11726:2017 describes procedures for validating alternative methods of analysis for coal and coke either directly by comparison with the relevant International Standard method or indirectly by comparison with reference materials that have been exhaustively analysed using the relevant International Standard method.
The statistical analysis methods used are parametric, i.e. their use is possible…
Reference conditions and procedures for testing industrial and process measurement transmitters - Pa...
IEC 62828-1:2017 establishes a general framework for defining reference conditions and test procedures applicable to all types of industrial and process measurement transmitters (PMTs) used in measuring and control systems for industrial process and machinery. These reference test conditions are divided into “standard reference conditions”, which apply when determining the accuracy of measurement…
Plastics — Injection moulding of test specimens of thermoplastic materials — Part 5: Preparation of ...
ISO 294-5:2017 specifies a mould (designated the type F ISO mould) for the injection moulding of plates with a preferred size of 80 mm × 120 mm and a minimum size of 80 mm × ≥90 mm and with a preferred thickness of 2 mm for single-point and multi-point data acquisition. It has been found to provide the maximum anisotropic properties, with only a slight sensitivity to the rate of injection.…
