Rechercher

This National Standard of Canada is based on International Standard ISO 15883-1:2006. 1 Scope This part of ISO 15883 specifies general performance requirements for washer-disinfectors (WD) and their accessories that are intended to be used for cleaning and disinfection of re-usable medical devices and other articles used in the context of medical, dental, pharmaceutical and veterinary practice…

Scope 1.1 Scope This Standard applies to the erection and use of access scaffold that is (a) supported on a surface; (b) hung from multiple points, but is not capable of moving vertically or horizontally; or (c) mounted on wheels. This Standard addresses key hazards, including fall hazards, structural instability, platform failures, and material handling problems. Note: In this Standard…

IEC 61477:2009 gives the minimum requirements relative to specification, manufacture, selection, application and maintenance of tools, devices and equipment for live working. It provides the type of information which is useful to skilled persons in order to make the use of tools, devices and equipment safer. This type of information includes: - the characteristics of tools, devices and equipment…

IEC 62192:2009 covers insulating ropes that are utilized during live working procedures in contact with parts of installations operating at voltages up to and including 800 kV r.m.s. Insulating ropes for live working procedure under rain and/or d.c. conditions are not covered by this standard.

ISO 23233:2009 specifies a method for the determination of the resistance of rubber to abrasion using a driven, vertical abrasive disc (the LAT 100: Laboratory Abrasion Tester 100). The loss in mass on abrasion is determined through the slip caused by setting different slip angles and rotational speeds between a wheel-shaped rubber test piece and an abrasive disc, rotating in planes at right…

ISO 4642-2:2009 specifies the requirements and test methods for semi-rigid reel hoses for use on fire fighting vehicles and trailer pumps. The hoses are intended for use at a maximum working pressure of 1,5 MPa for normal pressure hoses (category I) and 4,0 MPa for high pressure hoses (category II). The hoses are further subdivided into types and classes. ISO 4642-2:2009 applies to delivery hoses…

ISO/TR 230-8:2009 is concerned with the different types of vibration that can occur between the tool holding part and the work-piece holding part of a machine tool. (For simplicity, these will generally be referred to as “tool” and “work-piece”, respectively.) These are vibrations that can adversely influence the production of both an acceptable surface finish and an accurate work-piece. ISO/TR…

Scope This Code covers all electrical work and electrical equipment operating or intended to operate at all voltages in electrical installations for buildings, structures, and premises, including factory-built relocatable and non-relocatable structures, and self-propelled marine vessels stationary for periods exceeding five months and connected to a shore supply of electricity continuously or…

This National Standard of Canada is applicable to insulating hollow tubes made of synthetic materials and intended for tools and equipment for work on systems operating at voltages above 1kV.

ISO 15971:2008 concerns the measurement of calorific value of natural gas and natural gas substitutes by non‑separative methods, i.e. methods that do not involve the determination of the gas composition, nor calculations from it. ISO 15971:2008 describes the principles of operation of a variety of instruments in use for this purpose, and provides guidelines for the selection, evaluation,…