Rechercher

This National Standard of Canada is equivalent to International Standard ISo 10007:1995. 1 Scope This International Standard gives guidance on the use of configuration management in industry and its interface with other management systems and procedures. It first provides a management overview (clause 4), then describes the process, organization and detailed procedures. It is…

This National Standard of Canada is equivalent to International Standard ISo 10013:1995. 1 Scope This International Standard provides guidelines for the development, preparation and control of quality manuals tailored to the specific needs of the user. The resultant quality manuals will reflect documented quality system procedures required by the ISO 9000 family of International…

Provides brief summaries of the basic International Standards for determining emission sound pressure levels from all types of machinery at work station and at other specified locations and gives guidance on the process of selection. The guidance given does apply only to airborne sound.

1. Scope and Application 1.1 The Scope establishes that CSA Standard S136-94 applies to the design of cold formed steel structural members and that the design is based on limit states design (LSD) methods. Such members are roll or brake formed from carbon or low alloy flat-rolled steel products. Cold formed members find application where large surfaces are needed, as in deck and…

1. Scope 1.1 This standard applies to work suit systems that: - reduce thermal shock upon entry into cold water; - delay the onset of hypothermia during immersion in cold water; - provide acceptable flotation and minimize the risk of drowning; - do not impair the wearer's ability to perform his normal working duties. 1.2…

Applies to working standard microphones. Specifies mechanical dimensions and certain electroacoustical characteristics for working standard microphones used in measuring systems for the determination of sound pressure to enable these microphones to be used as transfer standards in the calibration of acoustic measurement instruments.

Is applicable to portable voltage detectors with or without a built-in power source to be used on electrical systems for voltages of 1 kV to 36 kV a.c., and frequencies from 15 Hz to 60 Hz. This part applies only to resistive voltage detectors used in contact with the part to be tested, as a single unit or as a separate device completed by an adaptable insulating pole covered in IEC 60855 or IEC…

7.1 Introduction Meticulous housekeeping and attention to detail are the keynotes of good darkroom work. It is important, therefore, that considerable attention be given to the process involved in the development and fixation, to the establishment of a standardized working routine, to the care and maintenance of equipment and also to the ability to trace the origin of faults other than…

1. Scope 1.1 These requirements apply to the following stationary equipment for use in nonhazardous locations rated 7200 V or less, single- or 3-phase, and remote control assemblies for such equipment. (a) Heat pumps, for heating and cooling with or without factory or field-installed electric resistance heaters, or hot water or steam heating coils. (b) Air conditioners for cooling…

1. Scope 1.1 This Standard covers polyethylene (PE) pipe, tubing, and fittings for use in potable cold water supply services. 1.2 This Standard includes requirements for material, quality of work, dimensions, sustained pressure, and environmental stress cracking. Methods of marking indicating compliance with this Standard are also included.