Rechercher

1. Scope 1.1 This Standard describes the design, construction, load rating, installation, erection, inspection, maintenance, repair, modification, test, and operation of lattice and telescopic boom mobile cranes. 1.2 This Standard applies only to machines that have all of the following fundamental characteristics: (a) the crane comprises, or is mounted on, a non- or self-propelled,…

This part of ISO/IEC 9314 specifies the Physical Layer Protocol (PHY), the upper sublayer of the Physical Layer, for Fibre Distributed Data Interface (FDDI). FDDI provides a high-bandwidth (100 Mbit/s), general-purpose interconnection among information processing systems, subsystems and peripheral equipment, using fibre optics or other transmission media. FDDI can be configured to support a…

This part of ISO/IEC 9314 specifies the Media Access Control (MAC), the middle sublayer of the Data Link Layer (DLL), for Fibre Distributed Data Interface (FDDI).FDDI (ISO/IEC 9314) provides a high-bandwidth (100 Mbit/s), general-purpose interconnection among information processing systems, subsystems and peripheral equipment, using fibre optics or other transmission media. FDDI can be configured…

Is applicable to two-pole voltage detectors to be used on electrical systems for nominal voltages not exceeding 1 000 V a.c. and/or 1500 V d.c and below 500 Hz (nominal frequencies). The detector types are classified as follows: voltage class A: up to and including 500 V a.c./750 V d.c.; voltage class B: up to and including 1 000 V a.c./ 1 500 V d.c. Low-voltage detectors covered by this…

1. Scope 1.1 This Standard applies to commercial refrigerator, refrigerator-freezer, and freezer cabinets that are intended for storing or holding food products and other perishable merchandise. 1.2 This Standard applies to (a) manufacturers' standard catalogue-type equipment; (b) closed cabinets of the unitary, self-contained type; (c) commercial refrigerated storage cabinets,…

1. Scope 1.1 This Standard specifies the requirements for all self-retracting devices (SRDs) used as connecting components in personal fall-arrest systems. SRDs are further classified in this Standard according to method of use and effective length. 1.2 The equipment specified in this Standard is intended for users at risk of potential falls from height while at work. 1.3 This Standard…

1. Scope 1.1 This Standard gives a group of common requirements that apply, unless otherwise specified in a purchase order or in an individual standard, to structural quality steel plates, shapes, hollow sections, sheet piling, cold-formed channels, and bars conforming to the requirements of CSA Standard G40.21. 1.2 The values stated in either SI (metric) or yard/pound units are to be…

1. Scope 1.1 This Standard covers structural quality steel plates, shapes, hollow sections, sheet piling, and bars for general construction and engineering purposes. 1.2 A number of strength levels are available under this Standard and are designated by the minimum yield strength in megapascals (ksi). The common grades, types, and strength levels are shown in Table 1. Charpy V-Notch…

This part of ISO/IEC 9314 specifies the Station Management (SMT) for the Fibre Distributed Data Interface (FDDI). FDDI provides a high bandwidth (100 megabits per second) general purpose interconnection among computers and peripheral equipment using optical fibre as the transmission medium in a ring configuration. FDDI can be configured to support a sustained transfer rate of approximately 80…

Preface This is the first edition of CSA Special Publication PLUS 9014, ISO 9000 Interpretations. It is a compendium of interpretations given on the ISO 9000 family of Standards and approved by the CSA Technical Committee on Quality Management (TC on QM). The ISO 9000 family of Standards was developed by quality experts from around the world, under the auspices of the Internationa l…