Rechercher

1 Scope 1.1 This Standard sets forth methods for both new installation and replacement installation of factoryassembled windows, exterior doors, and unit skylights that are intended for installation in low-rise buildings and buildings used primarily for residential occupancy where (a) the windows (including window wall) are (i) within the application of CAN/CSA-A440/A440.1; or (ii) R, LC,…

1.1 These requirements cover hose in nominal internal diameter sizes of 8 mm up to and including 32 mm for use on portable and wheeled fire extinguishers, hand hose line fixed extinguishing systems, and also as booster hose on fire apparatus. 1.2 Fire extinguisher, hand hose line system and booster hose covered by these requirements is intended for use at a maximum working pressure of 1400,…

This Standard covers barrel-type hydrants with compression shut-off and slide gate shut-off, for general water works service. This Standard does not cover wet barrel type hydrants. References to the setting and drainage of hydrants are not included in this Standard.

1.1 This Standard sets forth minimum requirements for hose and hose assemblies, including vapour recovery hose and assemblies, for use on dispensing devices for flammable and combustible liquids. For the purpose of this Standard flammable and combustible liquids mean gasoline, fuel oil, kerosene and diesel fuel, including gasoline with small amounts of additives such as detergents, solvents for…

Cover hose nozzle valves that are intended to be used to control the flow of flammable and combustible liquids. They are of the types used in the assembly of motor fuel dispensing equipment. Valves covered by this Standard are for use with flammable and combustible liquids which are handled at temperatures within the range of -40°C to + 50°C at a working pressure of not less than 350 kPa. For the…

This National Standard of Canada is equivalent to International Standard ISO/IEC 19501:2005. 1 Scope This standard specifies the Unified Modeling Language (UML) with the objective of providing system architects working on object analysis and design with one consistent language for specifying, visualizing, constructing, and documenting the artifacts of software systems, as well as for…

This Guide provides strategic principles, derived from market experience, for use by IEC and ISO technical committees and subcommittees working in the industrial automation sector, as well as other bodies within IEC and ISO with interests in the work of these committees.

This Guide provides strategic principles, derived from market experience, for use by IEC and ISO technical committees and subcommittees working in the industrial automation sector, as well as other bodies within IEC and ISO with interests in the work of these committees.

B181.0-06 Definitions, general requirements, and methods of testing for thermoplastic nonpressure piping 1 Scope 1.1 This Standard covers thermoplastic nonpressure piping, including (a) drain, waste, and vent pipe and pipe fittings; (b) sewer and storm pipe and pipe fittings; and (c) accessories such as factory-assembled expansion joints, closet flanges, backwater valves, and…

ISO 21012:2006 gives design, construction, type and production testing, and marking requirements for non-insulated cryogenic flexible hoses used for the transfer of cryogenic fluids within the following range of operating conditions: working temperature: from minus 270 °C to minus 65 °C;nominal size (DN): from 10 to 100. End fittings for mounting of any couplings are within the scope of this…