Rechercher

ISO 18243:2017 specifies the test procedures for lithium-ion battery packs and systems used in electrically propelled mopeds and motorcycles. The specified test procedures enable the user of this document to determine the essential characteristics on performance, safety and reliability of lithium-ion battery packs and systems. The user is also supported to compare the test results achieved for…

This technical document presents the guidelines for reporting the arc energies of test pieces from standards mentioned in ISO 15607 and transferring this data to a WPS for production welding for all arc welding processes.

This document defines requirements for collision warning (CWS) and collision avoidance systems (CAS) that address other forms of motion than forward/reverse and rotation for: — earth-moving machinery as defined in ISO 6165, — mobile underground mining machinery as defined in ISO 19296, rock drill rigs as defined in ISO 22935-5, and — road construction machinery as defined in ISO 22242. Clauses 5…

ISO 8913:2006 specifies requirements for lightweight polytetrafluoroethylene (PTFE) hose assemblies for use in aircraft hydraulic systems at temperatures between - 55 °C and 204 °C (- 65 °F and 400 °F), and at a nominal pressure up to 3 000 psi (20 684 kPa) or 21 000 kPa (3 046 psi). The hose assemblies are also suitable for use within the same temperature and pressure limitations in aircraft…

In 2006, the United States developed ISO 16792-2006 Technical product documentation-Digital product definition data practices adopted from the ASME Y14.41-2003 Digital product definition data practices. It was then revised and improved continuously. This standard is the basic standard for the three-dimensional digital design, which specifies how to add attributes, annotations, and other…

This document specifies design criteria for nuts specified in ISO 898-2 so that, under static tensile overload, the stripping fracture mode is prevented. The design criteria are also applicable to non-standardized nuts or internally threaded elements with ISO metric screw threads (in accordance with ISO 68-1) mating with bolts. However, dimensional factors such as the width across flats or other…

IEC 60601-1:2005+A1:2012, 1.1 is replaced by: This document applies to the basic safety and essential performance of medical supply units, hereafter also referred to as ME equipment. This document applies to medical supply units manufactured within a factory or assembled on site, including cabinetry and other enclosures, which incorporate patient care services. NOTE 1 A party that assembles on…

This part of standard wants to provide a testing and calculating methods for annual performance factor of sensible recovery ventilator ruled by the ISO 16494,It is the third part of ISO/NP5222.

Preparation of a new ISO standard using a recently published CEN standard as a basis. The WG will examine this in detail and make any technical changes as required to ensure conformance with specific ISO requirements It is expected that the ISO standard will closely follow the requirements of the published CEN standard whilst complying with the ISO template

This document specifies requirements and guidance for the installation on and removal from site of independent leg jack‑up units for use in the oil and gas industries including lower carbon energy. It addresses the assessment of: a)       the installation operation from when the jack-up enters the defined safety zone of the host platform or the intended site to when it is elevated to the…