Glass in building — Determination of the emissivity
This document specifies a procedure for determining the emissivity at room temperature of the surfaces of glass and coated glass.
The emissivity is necessary for taking into account heat transfer by radiation from surfaces at the standard temperature of 283 K in the determination of the U value and of the total solar transmittance of glazing.
The procedure, being based on spectrophotometric…
Fibre-reinforced polymer (FRP) reinforcement for concrete structures — Part 1: Specifications of FRP...
ISO 18319:2015 specifies requirements for fibre-reinforced polymer (FRP) sheets for upgrading of concrete members. The methodologies to express the mechanical properties as characteristic values, appearance and dimensions, and sampling test are specified in this International Standard. The properties for design are calculated from the characteristic values, as prescribed in an appropriate design…
Ship and marine technology — Hi-manganese austenitic steel — Plates, sheets and coils below 6,0mm fo...
This document specifies the delivery conditions for high manganese austenitic steel in forms of hot rolled or cold rolled plates, sheets, and coils for low temperature purposes.
This document does not purport to address all the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine…
Surface chemical analysis — Scanning probe microscopy — Guideline for the method and procedure for d...
This International Standard specifies the guidelines of the method and procedure for determining the effect of temperature on atomic force microscope (AFM) nano-scale dimension measurements. The effect of temperature can be evaluated by continuously measuring the changes of the X- and Y- pitches and height of a two-dimensional (2D) calibration grating in an environmental temperature controllable…
Steel — Determination of the non-metallic inclusion content — Micrographic method
ISO 4967:2013 specifies a micrographic method of determining the non-metallic inclusions in rolled or forged steel products having a reduction ratio of at least 3 using standard diagrams. This method is widely used to assess the suitability of a steel for a given use. However, since it is difficult to achieve reproducible results owing to the influence of the test operator, even with a large…
Information security, cybersecurity and privacy protection — Information security controls based on ...
ISO/IEC 27017:2015 gives guidelines for information security controls applicable to the provision and use of cloud services by providing:
- additional implementation guidance for relevant controls specified in ISO/IEC 27002;
- additional controls with implementation guidance that specifically relate to cloud services.
This Recommendation | International Standard provides controls and…
Environmental statements and programmes for products — Self-declared environmental claims
ISO 14021:2016 specifies requirements for self-declared environmental claims, including statements, symbols and graphics, regarding products. It further describes selected terms commonly used in environmental claims and gives qualifications for their use. This International Standard also describes a general evaluation and verification methodology for self-declared environmental claims and…
Ergonomics of the thermal environment — Evaluation of thermal environments in vehicles — Part 2: Det...
ISO 14505-2:2006 provides guidelines for the assessment of the thermal conditions inside a vehicle compartment. It can also be applied to other confined spaces with asymmetric climatic conditions. It is primarily intended for assessment of thermal conditions, when deviations from thermal neutrality are relatively small. Appropriate methodology as given in ISO 14505-2:2006 can be chosen for…
