Rechercher

1.1.1 This Standard applies to the construction and performance of new propane fuel system components providing motive power of highway vehicles utilizing internal combustion engines. 1.1.2 This Standard does not apply to stationary or non-highway applications. 1.1.3 This Standard does not apply to propane fuel system components incorporated during the manufacture of motor vehicles…

1.1 Specifies the requirements for zinc coating (galvanizing) by the hot-dipping process on iron and steel products made from rolled, pressed, or forged shapes such as structural sections, plates, bars, pipes, or sheets 1 mm thick and thicker. 1.2 This Standard applies to both unfabricated and fabricated products such as assembled steel products, structural steel fabrications, large…

This standard applies to fully wax or resin impregnated, water resistant, corrugated fibreboard boxes for use as interior or exterior shipping containers for domestic or overseas shipment of supplies.

This standard applies to products of corrugated fibreboard primarily for use as interior fittings in corrugated fibreboard boxes. Fibreboard boxes are covered by CAN/CGSB-43.21.

1.1 This standard states chemical and physical requirements for sodium soap in chip, powdered or granular form, suitable for commercial and institutional laundering. 1.2 Soap produced in accordance with this standard is intended for use in commercial and institutional laundering in soft water (calcium carbonate hardness up to 50 mg/L). It may be used with water of greater hardness if a…

Should be read in conjunction with ISO 8791-1. Applicable to all printing papers and boards with which it is possible to form a substantially airtight seal against the guard lands of the measuring head. Annex A gives a method of calculation of roughness, Annex B specifies maintenance of the roughness testers, Annex D its calibration against ISO reference standards.

Applicable to all iron ore fines that are agglomerated by the sintering process. Figure 1 gives an example of sintering test equipment, Figure 2 the flowsheet of typical sinter test procedure. Annex A lists international standards specifying the relevant test methods.

Specifies the dimensions necessary for interchangeability. Two filter element types, A and B, are specified. Types A and B are not interchangeable. This part of ISO 7750 may be used for other air filter applications where no specific standards exist.

This Code covers all electrical work and electrical equipment operating or intended to operate at all voltages in electrical installations for buildings, structures, and premises, including factory-built relocatable and non-relocatable structures, with the following exceptions: (a) Installations or equipment employed by an electric or communication utility in the exercise of its…