Rechercher

This National Standardof Canada is equivalent to Internationale Standard ISO/TR 14062:2002 (first edition, 2002-11-01). 1 Scope This Technical Report describes concepts and current practices relating to the integration of environmental aspects into product design and development, where .product. is understood to cover both goods and services. This Technical Report is applicable to the…

This National Standard of Canada is based on International Standard CEI/IEC 60104:1987, (second edition, 1987-12). 1 Scope This Standard is applicable to aluminium-magnesium-silicon alloy wires of two designations having different mechanical and electrical properties for the manufacture of stranded conductors for overhead power transmission purposes. It specifies the mechanical and…

1. SCOPE 1.1 This method is applicable to the finished surface or covering of a floor extending to a maximum depth of 65 mm. It may also be applied to materials that cannot conveniently be tested in a ceiling mounted configuration. Thermoplastic and loose fill materials might be included in this category. 1.2 The primary purpose of the test is to determine the comparative burning…

1. SCOPE 1.1 This method of test for surface burning characteristics of building materials is applicable to any type of building material that, by its own structural qualities or the manner in which it is applied, is capable of supporting itself in position or may be supported in the test furnace to a thickness comparable to its recommended use. NOTE: For materials which cannot be so…

1. SCOPE 1.1 The test methods described in this Standard are applicable to roof covering materials and are intended to measure the relative fire-performance characteristics of roof coverings when exposed to fire originating from sources outside a building on which they may be installed. They are applicable to roof coverings intended for installation on either combustible or non-combustible…

ISO 4952 specifies the chemical and mechanical characteristics, methods of manufacture, the acceptance conditions and the marking of structural steel products possessing improved atmospheric corrosion resistance. It applies to plates having a thickness of 4 mm and over, hot-rolled on reversing mills, wide flats, bars and hot-rolled sections generally used in the delivery condition and which, as a…

Specifies requirements for the performance characteristics of neutron ambient dose equivalent (rate) meters, and prescribes the methods of testing in order to determine compliance with this standard. Specifies general characteristics, general test procedures, radiation characteristics, electrical, mechanical, safety and environmental characteristics, and also the identification certificate

ISO 3251:2003 specifies a method for determining the non-volatile-matter content by mass of paints, varnishes, binders for paints and varnishes, polymer dispersions and condensation resins such as phenolic resins (resols, novolak solutions, etc.). The method is also applicable to formulated dispersions containing fillers, pigments and other auxiliaries (e.g. thickeners and film-forming agents).…

ISO 15084:2003 specifies requirements for strong points for attaching chains, cables and lines for anchoring, mooring and towing small craft. It does not specify the requirement for the strong point from which the craft can tow other vessels. This standard is applicable to small craft with a hull length up to 24 m. ISO 15084:2003 does not define anchor weights or the length of chains and lines.

ISO 5167-3:2003 specifies the geometry and method of use (installation and operating conditions) of nozzles and Venturi nozzles when they are inserted in a conduit running full to determine the flow-rate of the fluid flowing in the conduit. ISO 5167-3:2003 also provides background information for calculating the flow-rate and is applicable in conjunction with the requirements given in ISO 5167-1…