Rechercher

Scope 1.1 This standard describes the recommended procedures to be employed in applying filled cutback asphalts, covered by CGSB 37-GP-16M, in dampproofing or waterproofing footings, floors, walls and structural slabs.

1. Scope 1.1 This Standard covers the features of single-phase submersible transformers. For other details, reference shall be made to CSA Standard C2, Single-Phase and Three-Phase Distribution Transformers Types ONAN and LNAN, hereinafter referred to as CSA Standard C2. Note: See Appendix A, Recommendations for Corrosion Control of Submersible Transformer Installations, which covers…

Scope 1.1 This standard applies to two types of gasoline suitable for use in automative and spark ignition engines operating under all climatic conditions.

1. Scope 1.1 This Standard applies to portable and stationary, incandescent and electric-discharge-lamp (fluorescent, mercury- and sodium-vapour) luminaires of the swimming-pool type and of the submersible type intended for use in other than swimming pools. The luminaires are for connection to a supply circuit of 150 v olts and less between conductors, designed to be installed and used in…

Scope This standard applies to fibrated cutback tar for use as a sprayed or bushed-on coating for coal tar built-up roofs.

1. Scope 1.1 This Standard applies to complete flue-connected, oil-fired steam and/or hot-water low pressure boilers, provided with automatic control devices. 1.2 This Standard applies to boilers intended for residential use having an input of less than 3 gallons per hour (US) (approximately 400,000 Btu/h). Note: A boiler which has an input exceeding this limit may be considered…

Definition 1.1 this standard applies to filled cutback asphalt for use by brush or spray for dampproofing and waterproofing masonry and concrete walls below grade, and for dampproofing and waterproofing concrete floors.

Specifies for fully threaded screws with machined, or rolled threads pitches of the thread ranging from 0,2 mm to 6 mm and thread diameters (coarse thread) ranging from 1 mm to 68 mm; it does not apply to those threaded fasteners where special requirements are laid down in the product standards.

Applies to three phase alternating current systems having a highest voltage for equipment above 1 kV. Specifies the procedures for the selection of the standard withstand voltages for the phase to earth, phase to phase and longitudinal insulation of the equipment and the installations of these systems. Supersedes sections 2 and 3 of IEC 71-3.

Applies to audio-frequency peak programme level meters, for use in equipment for broadcasting, sound reinforcement, sound recording and household entertainment. This part does not apply to Standard volume indicators which are dealt with in IEC 268-17. This edition supersedes the first edition of IEC 268-10 (1976) and its supplement 268-10A (1978).