Rechercher

1. Scope 1.1 This Standard applies to switching and metering centres (hereafter may be referred to for convenience as metering centres or centres) rated 600 V and less, intended to be used in accordance with the Rules of the Canadian Electrical Code, Part I, in nonhazardous locations, to provide switching, overcurrent protection and metering for a number of circuits supplied from a consumer…

Defines the conventional impact bodies used in order to reproduce the effect of actual impacts on vertical building elements as well as the general test procedures and the test procedures specific to each type of building element tested being given in the standards specific to these building elements. Applies to all vertical building elements excluding doorsets.

Applies to pre-recorded capacitance grooveless videodiscs for the 60 Hz/525 lines - NTSC compatible system and gives dimensional and other characteristics necessary to ensure interchangeability of the videodisc. Serves as a reference for manufacturers intending to make discs or players compatible with the system described in the standard. See IEC 1106.

Applies to all electronic control and regulation equipment, etc., with the exception of electronic power-circuits which conform to IEC 411 and IEC 411-1.

1.1 This standard applies to liquefied petroleum gas (LPG) consisting essentially of butane and/or butylenes. 1.2 The liquefied petroleum gas is intended for use in gas burning equipment in the generation of heat for domestic and industrial purposes where a low volatility liquefied petroleum gas is required.

This standard applies to window drapes made from suitable woven fabrics and supplied complete with hooks and rod for commercial use.

1.1 This standard applies to a hard film type of solvent-dispersed rust preventive compound with a minimum flow point of 80 degrees C for the nonvolatile fraction. 1.2 For details on uses see par. 7.2.

Specifies requirements for polyurethane-coated fabrics for upholstered furniture, where a substantially continuous coating is applied to one side of the fabric. Two annexes for the selection of the specimen and for the determination of the resistance to print wear. Part 1 of this standard: PVC-coated knitted fabrics; part 2: PVC-coated woven fabrics.

Applies to newly produced outdoor gas grills (see "Definitions", Part 3) constructed entirely of new, unused parts and materials. Outdoor gas grills submitted for examination under this Standard shall be classified as portable or stationary.

1. SCOPe 1.1 This standard applies to a high-density felt with not less than 50% animal fibre content, for packing, padding and crating, where a firm, semi-hard material is required. This felt is not intended for use in ammuniation components. 1.2 For more detailed information on intended uses, see par. 7.2. 1.3 This standard may require the use of materials and/or equipment that…