1 Scope
1.1
This Standard specifies performance, design, testing, marking, classification, and other requirements related to anchorage connectors in travel-restraint, fall-arrest, work-positioning, and suspended component/tie-back line systems.
1.2
The requirements of this Standard include (where applicable) anchorage connectors attached to an anchorage. Methods of verifying the actual…
w-Voltage Fuses – Part 18: Class CD Fuses
1 Scope
1.1 This Part is intended to be read together with the Standard for Low-Voltage Fuses – Part 1: General
Requirements, hereafter referred to as Part 1. The titles of the Clauses in this Part correspond to the
similarly titled Clauses in Part 1. The requirements of Part 1 apply unless modified by this Part. For the
Part 1 requirements, refer to…
1 Scope
1.1 This Part is intended to be read together with the Standard for Fuseholders – Part 1: General
Requirements, hereafter referred to as Part 1. The titles of the Clauses in this Part correspond to the
similarly titled Clauses in Part 1. The requirements of Part 1 apply unless modified by this Part. For the
Part 1 requirements, refer to the Standard for Fuseholders – Part 1: General…
Household and similar electrical appliances — Safety — Part 2-69: Particular requirements for wet an...
1 Scope
This clause of Part 1 is replaced by the following.
This part of IEC 60335 deals with the safety of electrical motor-operated vacuum cleaners, including BACKPACK
VACUUM CLEANERS, and DUST EXTRACTORS, for wet suction, dry suction, or wet and dry suction,
intended for commercial indoor or outdoor use with or without attachments. They may be provided with a
blowing or inflating function…
Laboratory resistors - Part 1: Laboratory DC resistors
IEC 60477-1:2022 applies to resistors intended for use as laboratory DC resistors (hereinafter referred to as "resistors") comprising standard resistors, single or multiple resistors of accuracy Classes 0,000 05 to 10 and single or multi-dial resistors of accuracy Classes 0,000 5 to 10.
This document does not apply to:
1) resistors which are intended for use solely as permanently…
Terrestrial photovoltaic (PV) modules - Design qualification and type approval - Part 1-4: Special r...
IEC 61215-1-4:2021+AMD1:2022 lays down requirements for the design qualification of terrestrial photovoltaic modules suitable for long-term operation in open-air climates. The useful service life of modules so qualified will depend on their design, their environment and the conditions under which they are operated. Test results are not construed as a quantitative prediction of module lifetime.…
1 Scope
1.1 This standard applies to bare and covered ferrules intended for field wiring and factory wiring for use
in accordance with the National Electrical Code, ANSI/NFPA-70, and Canadian Electrical Code, Part I,
CSA C22.1.
1.2 Ferrules covered by this standard are intended to facilitate the connection of stranded wire onto
devices, such as terminal blocks and mechanical wire connectors…
Communication networks and systems for power utility automation - Part 5: Communication requirements...
IEC 61850-5:2013+AMD1:2022 applies to power utility automation systems with the core part of substation automation systems (SAS); it standardizes the communication between intelligent electronic devices (IEDs) and defines the related system requirements to be supported. The major technical changes with regard to the previous edition are as follows:
- extension from substation automation systems…
Coaxial communication cables - Part 11: Sectional specification for semi-rigid cables with polyethyl...
IEC 61196-11:2022 specifies the general requirements of semi-rigid coaxial communication cables with polyethylene (PE) dielectric, including material and construction, IEC type designation, identification, marking and labelling, standard ratings and characteristics, requirements of finished cables, quality assessment, delivery and storage, etc.
This part of IEC 61196 applies to semi-rigid…