Rechercher

This document specifies the minimum operational, functional and performance requirements, as well as methods of testing and the corresponding required test results, for heading control systems installed on board ships conforming to performance standards adopted by IMO Resolution MSC.64(67), Annex 3. In addition, it takes into account parts of IMO resolution A.694(17) to which IEC 60945 is…

This document specifies rules for presentation of aspheric surfaces and surfaces with low order symmetry such as cylinders and toroids in the ISO 10110 series, which standardizes drawing indications for optical elements and systems. It also specifies sign conventions and coordinate systems. This document does not apply to off-axis aspheric and discontinuous surfaces such as Fresnel surfaces or…

This document provides general principles for the systematic evaluation of the potential and observed degradation of medical devices through the design and performance of in vitro degradation studies. Information obtained from these studies can be used in the biological evaluation described in the ISO 10993 series. This document is applicable to both materials designed to degrade in the body as…

This document specifies switch and crossing rails that carry railway wheels as specified in ISO 5003. These are used in conjunction with flat bottom (vignole) railway rails. After switch and crossing rails are produced, in order to be ready for railway track use, secondary processing (forging, grinding and heat treatment etc.) is carried out. This document does not include secondary processing.…

This document gives the determination of aggregate crushing value (ACV) of aggregates. This gives a relative measure of the resistance of the aggregate crushing under the gradually applied compressive load. The method is applicable to aggregates passing a 14,0 mm test sieve and retained on a 10,0 mm test sieve. For other size fractions, a recommended method is described in Annex A. The aggregate…

This document specifies the fundamental formulae for use in the determination of the surface load capacity of cylindrical gears with involute external or internal teeth. It includes formulae for all influences on surface durability for which quantitative assessments can be made. It applies primarily to oil‑lubricated transmissions, but can also be used to obtain approximate values for (slow‑…

This document specifies the fundamental formulae for use in tooth bending stress calculations for involute external or internal spur and helical gears with a rim thickness sR > 0,5 ht for external gears and sR > 1,75 mn for internal gears. In service, internal gears can experience failure modes other than tooth bending fatigue, i.e. fractures starting at the root diameter and progressing…

This document specifies the information and standardized conditions necessary for the calculation of the service life (or safety factors for a required life) of gears subject to variable loading for only pitting and tooth root bending strength. If this scope does not apply, refer ISO 6336-1:2019, Clause 4.

This document specifies basic attributes which are required to describe data elements and associated metadata, and which might be used in situations where a complete ISO/IEC 11179-3 metadata registry is not appropriate (e.g. in the specification of other International Standards).

IEC 61810-1:2015 applies to electromechanical elementary relays (non-specified time all-or-nothing relays) for incorporation into low voltage equipment (circuits up to 1 000 V alternate current or 1 500 V direct current). It defines the basic functional and safety requirements and safety-related aspects for applications in all areas of electrical engineering or electronics, such as: general…