Rechercher

IEC 61156-6:2020 describes the cables intended primarily for working area wiring as defined in ISO/IEC 11801 (all parts). It covers cable designs comprising individually screened, common screened and unscreened pairs or quads. The transmission characteristics and the frequency range of the cables are specified at 20 °C. These cables can be used for various communication channels which use as many…

1 Scope 1.1 This Standard applies to portable luminaires, intended for use in dry, damp, and wet locations, and intended to be used in accordance with the Rules of CSA C22.1, Canadian Electrical Code, Part I, in non- hazardous locations, on a nominal 120 V system and 15 or 20 A branch circuits, or on the load side of a Class 2, LED Class 2, or safety extra-low voltage (SELV) circuit. 1.2 This…

1 Scope 1.1 1.1.1 The requirements specified in this Standard cover light-emitting diode (LED) equipment that is an integral part of a luminaire or other lighting equipment and that operates in the visible light spectrum between 400 and 700 nm. These requirements also cover the component parts of LED equipment, including LED controlgear, controllers, arrays, modules, and packages, as…

1 Scope 1.1 This Standard covers outdoor and wet location, light-sensitive, photo-electric control units of the plug- in, locking type, rated 600 V, 60 Hz ac or less, that are intended for controlling electric luminaires of the magnetic ballast, electronic ballast, tungsten-filament type, or light-emitting-diode (LED) and their associated driver, and that are intended to be employed for area…

1 Scope This clause of Part 1 is replaced by the following. This International Standard deals with the safety of cosmetic and beauty care appliances incorporating lasers or intense light sources for household and similar purposes, where their operation relies on contact with the skin, their rated voltage being not more than 250 V. NOTE 101 Battery-operated appliances and other d.c. supplied…

1 Scope 1.1 This Standard covers integral horsepower, three-phase, alternating current, squirrel cage induction motors rated up to 15 kV at 50/60 Hz. This Standard also covers inverter duty motors. 1.2 The values given in SI units are the units of record for the purposes of this Standard. The values given in parentheses are for information and comparison only. 1.3 In this Standard, “shall”…

1 Scope This clause of Part 1 is replaced as follows: 1.1 This standard applies to the evaluation of thermal protectors for ballasts for tubular fluorescent lamps. Requirements concerning the testing of the combination of ballast and thermal protector are given in IEC 920. Requirements concerning the testing of the combination of ballast and thermal protectors are given in CAN/CSA-…

1 Scope This International Standard provides guidance on the selection and application of techniques for assessing risk in a wide range of situations. The techniques are used to assist in making decisions where there is uncertainty, to provide information about particular risks and as part of a process for managing risk. The document provides summaries of a range of techniques, with…

1 Scope 1.1 This Standard specifies tests and requirements for the flexible fuel line or vent line for service temperatures colder than –40 °C (–40 °F) and cryogenic conditions, a liquefied natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833. This Standard is not applicable to the following: a) fuel containers; b) stationary gas engines; c…

1 Scope 1.1 General 1.1.1 This Standard applies to newly manufactured LNG dispenser fuelling and vent hose emergency breakaway shutoff devices, hereinafter referred to as devices. Notes: 1) Devices covered in this Standard are intended to be used on an LNG dispenser certified to CSA LNG 4.1 and with an LNG refuelling connector in accordance with ANSI/CAN/CSA-ISO 12617. 2) Both “one-time…