1. SCOPE
1.1 This standard applies to four types of erasers suitable for removing
pencil writing, ink pen writing, ballpoint ink writing, typewriting,
carbon copy and drawing cleaning.
1. Scope
1.1 This Standard applies to the measurement of the concentration of carbon monoxide in samples taken from ambient air, enclosed gas streams, and gases under pressure.
1.2 This Standard sets forth the following two applicable procedures for the measurement of the concentration of carbon monoxide:
(a) Non-dispersive Infrared Spectrometry, which is intended for use where…
Cinematography — Sprockets for 8 mm Type S motion-picture film — Dimensions and design
This International Standard lays down the dimensions and specifies requirements for the design of sprockets used with 8 mm Type S motion-picture raw stock or processed film.
Is based on Standard No.106 of the International Assotiation for Cereal Science and Technology (ICC). The method consists inpreparing of dough from a sample of flour and a buffered solution of sodium chloride, isolating of the wet gluten by washing this dough with a buffered solution of sodium chloride ( washing out by hand or mechanical washing out ), followed by removing of exess washing…
Road vehicles — Visibility — Method for establishment of eyellipses for driver's eye location
Establishes two-dimensional eyellipses representative of driver eye locations corresponding to the 90th, 95th, and 99th percentiles. The statistical representation of the driver's eye location contained in this Standard applies as a design tool to those road vehicles referred to in subclause 3.1.1 of ISO 3833. Some figures illustrate shapes and reference quantities of concern.
This Standard pertains specifically to a class of board made predominantly of
wood particles of a specified size and shape (wafers), bonded with a water and
boil proof binder to a specified level of bending strength after a 2-hour boil
test. This class of board is used extensively in exterior construction
applications requiring durability and load carrying capacity. This Standard
specifies…
Standard Test Methods for Mat-Formed Wood Particleboards and Waferboard
This standard is one of the CAN3-O188 Series of Standards on
Particleboard and Waferboard. It describes the test procedures
for determining dimensional tolerances, density and moisture
content, static bending strength, internal bond strength,
hardness, screw-holding strength, linear expansion and nail
withdrawal resistance of particleboard and waferboard.
Additionally this standard…
Methods of Testing Putty, Caulking and Sealing Compounds
Contains general physical and chemical methods of testing putty,
caulking and sealing compounds for conformance with the standards
of the Canadian Government Specifications Board.
Measuring Viscosity of Letterpress and Lithographic Inks with the Falling
Rod Viscometer
This standard applies to a method for determining the plastic viscosity and yield value of letterpress and lithographic inks by use of the Falling Rod Viscometer. Viscosity tables are provided for conversion of fall times to viscosity and yield values.
1. SCOPE
1.1 This standard applies to priming paint suitable for interior and exterior
use on steel, aboard ships under conditions of marine atmosphere and
intermittent immersion in salt water.
1.2 For additional information on intended uses, see par. 7.2.
