Rechercher

Provides a basis for relating joint clearances and target sizes and for the prediction of fit within the context of dimensional coordination, including modular coordination. Is intended for use by component manufacturers when determining target sizes for standard components and by building designers when determining target sizes for construction on site, assessing the applicability of standard…

Belongs to a series of standards concerned with the major subjekt; further parts will extend the range by using larger flames. The measurements are intended for a combination of materials used in upholstered seating and not for a particular finished item of furniture incorporating these material. They only give an indication of, but cannot guarantee, the ignition behaviour of the finished item of…

This National Standard of Canada is equivalent to International Standard ISo 8072-1988. 1. Scope and field of application This International Standard defines in an abstract way the externally visible service provided by the OSI Transport Layer in terms of a) the primitive actions and events of the service; b) the parameter data associated with each primitive action…

1. Scope 1.1 This Standard applies to structures and hoists that are not a permanent part of buildings, structures, or other works, and that are used during construction, alteration, or demolition to raise and lower persons and/or materials connected with or related to a building project. 1.2 This Standard covers the design, construction, installation, operation, and acceptance…

This National Standard of Canada is equivalent to International Standard ISo 8073-1986. 1. Scope and field of application This International Standard specifies a) five classes of procedures: 1) class 0: simple class; 2) class 1: basic error recovery class; 3) class 2: multiplexing class; 4) class 3:…

Covers requirements for construction, marking, instruction and tests of a general nature that are applicable to all or several of the individual Standards in the B140 Series.

1. Scope 1.1 This Standard covers the electrical and mechanical properties of round wire, concentric lay, overhead electrical conductors made of combinations of any of the following metal wires: (a) 1350-H19 (hard-drawn) aluminum, designated A1; (b) 6101-T81 aluminum alloy, designated A2; (c) 6101-T83 aluminum alloy, designated A4; (d) 5005-H19 aluminum alloy, designated A5; and…

Adds an Appendix A: Standardized schematic diagrams and pin identifications for fixed resistor networks.

1. Scope 1.1 This Standard applies to fuseholder assemblies, rejectors for Type C fuses, adapters for Type S fuses, and the current-carrying parts pertaining thereto and mounted on bases of suitable insulating material, designed to be employed in accordance with the Canadian Electrical Code, Part I. 1.2 Fuseholder assemblies covered by this Standard are intended to accept only the following…