Rechercher

1. Scope This Standard covers requirements for the general and specific characteristics of rubber floor tile.

1. Scope 1.1 This Standard covers test methods for resilient floor coverings (tile and sheet) and resilient wall base. It is part of the A126 series and includes all test methods referenced in the other Standards in this series.

Describes the colorimetric terms and fundamental requirements necessary for determining the colour co-ordinates of paint films. From among the various colour co-ordinates recommended by the CIE, the colour co-ordinates in the CIE 1964 supplementary standard colorimetric system and the colour co-ordinates in the colour space specified in CIE 1976 for measurements on paint films are in accordance…

Lays down the appropriate rules applying to standardized lifts of class I and permitting the number of lifts and their main characteristics to be defined at the very beginning of building design. Three quality levels are specified for the lift service. Part 1 covers the lifts of classes I, II and III, part 2 the lifts of class IV, part 3 service lifts of class V and part 5 control devices,…

Is one of a series of International Standards dealing with the conversion of systems of writing, following the principles of stringent conversion in order to permit international information exchange. Its aim is to provide a means for international communication of written messages in a form which permits the automatic transmission and reconstitution of these by men or machines.

The different approaches to the drafting of International Standards resulted in a lack of uniformity in the technical content, and in the layout and sequence of the subject matter, of such documents. This Technical Report has, therefore, been prepared to create guidelines for the presentation of International Standards dealing with the design of structures.

The tests contained in this standard, when required by the detail specification, shall be used for electromechanical components having an inherent connecting or switching function intended for use in equipment for telecommunication and in electronic devices employing similar techniques.

1. Scope 1.1 This Standard applies to rigid unplasticized poly(vinyl chloride) conduit, elbows, bends, and couplings intended for use at a continuous operating temperature of 75°C for the installation of wires and cables in accordance with the Rules of the Canadian Electrical Code, Part I, for nonhazardous locations. Note: See Canadian Electrical Code, Rule 12-1204. 1.2 The products…

Scope 1.1 This standard applies to a sheet applied elastomeric membrane for use in roofing and waterproofing. 1.2 For further information regarding intended uses, see par. 8.2.

Specifies the minimum qualifications, in terms of performance objectives, of personnel responsible for the installation, servicing and inspection of solid fuel burning systems of the type covered by CSA Standard B365-M1982. This standard also specifies the minimum qualifications, in terms of performance objectives, of personnel responsible for chimney sweeping and venting maintenance.