1. DEFINITION
1.1 This standard applies to metal shelves designed to be mounted
on 60 x 30 inch modular desks or tables that conform to
44-GP-150 and 44-GP-154 respectively.
Système de Tailles Canada Standard des vêtements pour filles et garçons
Décrit le système de base de Tailles Canada Standard pour
vêtements de filles et garçons. Elle expose les étapes de
l'élaboration du système et regroupe sous forme de tableaux les
mensurations en unités métriques pour les catégories normalisées
de tailles représentant presque toute la population masculine et
féminine d'âge compris entre deux à trois ans jusqu'à la fin de
l'…
Canada Standard System for Sizing Girls' and Boys' Apparel
This standard describes the basic Canada Standard sizing system for determining the body size of boys' and girls'. It outlines the development of the system and provides in tabular form body measurements in metric units for standard size ranges covering practically all male and female members of the population from about two to three years of age until they reach their middle to upper…
1. Scope
1.1 This Standard provides a testing procedure for defining a minimum level of structural adequacy and performance capability for running gear used under trailers, sectional homes, and mobile homes, but excludes trailers equipped with full air brakes or vehicles not required to be licensed for highway use.
1.2 This Standard covers general requirements and performance tests…
Canada Standard System for Sizing Girls' and Boys' Apparel
Describes the basic Canada Standard sizing system for determining
the body size of boys and girls. It outlines the development of
the system and provides in tabular form body measurements in
metric units for standard size ranges covering practically all
male and female members of the population from about two to three
years of age until they reach their middle to upper teens. This
sizing…
1. Scope
1.1
This Standard applies to heat pump water heaters and refrigerant desuperheaters
rated at 600 V or less, designed to be installed indoors in accordance with the
Rules of the Canadian Electrical Code, Part I, and the applicable local
Plumbing Code.
1.2
This Standard applies to packaged heat pump water heaters (which hereinafter
may be referred to as "equipment")…
1. Scope
1.1 This Standard applies to voltage and polarity testers for use in nonhazardous locations, in accordance with the Rules of the Canadian Electrical Code, Part I, on electrical supply circuits and equipment at points where the voltage difference does not exceed 750 V.
1.2 This Standard does not apply to a device primarily intended to measure voltage, such as one that employs a…
Methods of test for winding wires. Part 1: General.
Gives methods for calculating the cyclic rating factor for cables
where the internal thermal capacitance can be neglected.
The simplified methods in this standard require only a knowledge of
the full shape of the load variation for not more than 6h
immediately preceding the time of maximum temperature and an
average value for times before that.
Rubber- or plastics-covered rollers — Specifications — Part 3: Dimensional tolerances
Specifies classes of dimensional tolerances and test methods for the measurement of dimensions. Defines covered rollers as cylindrical cores, generally of metal, with a cover of rubber or plastics for particular use. They are manufactured in a wide variety of sizes and hardness grades depending on the intended use. - Part 1 and 2 of this standard deal with the requirements for hardness, and the…
