International Electrotechnical Vocabulary (IEV) - Part 604: Generation, transmission and distributio...
The contents of the corrigendum of July 1987 have been included in this copy. It has the status of a horizontal standard in accordance with IEC Guide 108.
Electrical test methods for electric cables. Part 1: Electrical tests for cables, cords and wires fo...
This part is a re-edition of Clause 16 of IEC 60540.
The electrical test methods described in this standard are given as a guide to be followed for testing wires, cords and cables where the relevant cable standard does not prescribe a different electrical test method.
The electrical tests are only applicable to:
-unsheathed wires, cords and cables;
-cores taken from complete sheathed cords and…
Radio-frequency connectors. Part 1: General requirements and measuring methods
Serves as a generic specification providing the basis for the sectional standards which apply to individual connector types. Establishes uniform concepts and procedures concerning : -terminology; -standard ratings and characteristics; -testing and measuring procedures concerning electrical electrical and mechanical properties; -classification of connectors with regard to environmental testing…
Mechanical standardization of semiconductor devices. Part 4: Coding systems and classification into ...
Gives recommended practice for the designation of package outlines and for the classification into forms of package outlines for semiconductor devices.
Refractory materials — Determination of thermal conductivity — Part 1: Hot-wire method (cross-array)
Belongs to a series of standard and specifies a hot-wire method for the determination of the thermal conductivety of refractory products. The method is applicable at temperatures not higher than 1250 °C and to materials whose thermal conductivity is less than 1,5 W/(m.k) and whose thermal diffusivity is less than 10-6 m2/s. Subject to the limits in 1.2, the method is applicable to powdered or…
Adhesives — Wood-to-wood adhesive bonds — Determination of shear strength by tensile loading
The method is intended for testing adhesives used in bonding wood to wood. Standard specimens are prepared from timber plies. The test specimens shall be of a two-ply or three-ply construction with notches as shown in a picture. The shear area is 20 mm x 25 mm. The adhesive shall be applied in accordance with the procedure recommended by the manufacturer of the adhesive. The mean tensile shear…
Air-conditioning and ventilation of machinery control-rooms on board ships — Design conditions and b...
Applies to seagoing merchant ships for all conditions except those encountered in extremely cold or hot climates. Applicable parts of this Standard can be used for similar spaces. The annex provides guidance and details of good practice in the design of ventilation and air-conditioning systems for machinery control rooms.
Standard for Smoke Detectors for Fire Alarm Systems
1. SCOPE
1.1 This Standard sets forth requirements for ionization-type and
photoelectric-type detectors, rated at 300 V or less, to be employed in
ordinary indoor locations in accordance with the following:
A Standard for the Installation of Fire Alarm Systems, CAN/ULC-S524M;
B Standards of the National Fire Protection Association:
No. 71,…
Covers requirements for speakers for voice and tone reproduction
for use in accordance with the Standard for the Installation of
Fire Alarm Systems, CAN/ULC-S524-M86, and in accordance with the
Canadian Electrical Code, Part I.
