Rechercher

Applicable to the inspection of tubes with an outside diameter greater than or equal to 9 mm. Specifies general requirements, method of test, reference standards, reference notches, equipment calibration and checking, acceptance and test report. Annex A gives notes on limitations of the magnetic transducer/flux leakage technique.

S'applique aux dimensions considérées essentielles pour la fabrication de mannequins utilisés pour évaluer l'ajustement de vêtements destinés aux filles (Tailles Canada Standard, tailles courantes pour filles 3, 4, 6 et 10) et aux garçons (Tailles Canada Standard, tailles courantes pour garçons 3, 4, 6 et 10). Les dimensions de trois types de mannequins (types A, B et C) sont données.

This National Standard of Canada is equivalent to International Standard ISO 8649-1988. It defines ACSE services for application-association control in an open systems interconnection environment. The ACSE services are provided by the use of the ACSE protocol (ISO 8650) in conjunction with the presentation-service (ISO 8822). The ACSE services assume as a minimum the use of the…

This National Standard of Canada is equivalent to International Standard ISO 8650-1988. 1 Scope and Field of Application The procedures defined in this International Standard are applicable to instances of communication between systems which wish to interconnect in an open systems interconnection environment. This International Standard specifies: (a) procedures for the transfer of…

Applies to the dimensions considered essential for the construction of model forms used to assess fit of garments for wear by girls (Canada Standard Sizes Girls' Regular Range Sizes 3, 4, 6 and 10) and boys (Canada Standard Sizes Boys' Regular Range Sizes 3, 4, 6 and 10). Dimensions of three types of forms (Types A, B and C) are provided.

1.1 This standard applies to reinforced liquid asphaltic materials in the form of aqueous emulsions of the mineral colloid type for use as sprayed, trowelled or brushed-on coatings for built-up roofs and other roof surfaces, and for waterproofing concrete or masonry surfaces. 1.2 For more detailed information on intended uses and methods of application see par. 7.2 and 7.3.

1.1 This standard applies to sliding doors that are primarily intended to be installed in exterior walls of buildings. 1.2 Power assisted, industrial grade, and garage doors were not considered in the preparation of this standard.

This National Standard of Canada is equivalent to International Standards ISO 8879-1986 and ISO 9069-1988. 1 Scope This International Standard: (a) Specifies an abstract syntax known as the Standard Generalized Markup Language (SGML). The language expresses the description of a document's structure and other attributes, as well as other information that makes the markup…

These requirements cover the design and construction of Type L Vents which are intended for the venting of flue gases having temperatures not exceeding 300 degrees C, from fuel-burning appliances certified for use with Type L Vents. They may also be used where Type B gas vents are used. They are intended for installation in buildings to provide an essentially vertical conduit or passageway for…

This standard is applicable both to capacitor units and capacitor banks intended to be used for power-factor correction of a.c. power systems having a rated voltage up to and including 660 V and frequencies 15 Hz to 60 Hz. Supersedes IEC 70.