Rechercher

This part gives of the limit deviations for commonly used tolerance classes calculated from the information given in ISO 286-1. It covers values for the upper and the lower deviations which are illustrated by a figure. It tabulates numerical values for basic sizes from 3 mm up to and including 3150 mm. An annex gives a graphical review of tolerance zones.

Applies to newly produced outdoor gas grills (see "Definitions", Part 3) constructed entirely of new, unused parts and materials. Outdoor gas grills submitted for examination under this Standard shall be classified as portable or stationary.

1. SCOPe 1.1 This standard applies to a high-density felt with not less than 50% animal fibre content, for packing, padding and crating, where a firm, semi-hard material is required. This felt is not intended for use in ammuniation components. 1.2 For more detailed information on intended uses, see par. 7.2. 1.3 This standard may require the use of materials and/or equipment that…

1. Scope 1.1 This Standard addresses monitors intended for the detection of interruptions of the patient's breathing gas during controlled ventilation in anaesthesia by monitoring pressure in the breathing circuit. It does not address monitors based on gas composition, flow, or exhaled volume. Notes: (1) Applications for critical care ventilation are not considered but may be…

Applies to the design of highway bridges that have spans up to l00 m, and is based upon the limit states design theory. It sets forth minimum requirements that are consistent with current practice. Modifications may be necessary in order to adapt the Standard for use in the design of a specific bridge, unusual types of bridges, and bridges with spans longer than 100 m.

1.1 This standard applies to a soft film type of solvent-dispersed rust preventive compound with water displacing properties. 1.2 For details on uses see par. 7.1.

1. Scope and Field of Application This Standard is an Application Layer Standard within the Open Systems Interconnection framework defined by CSA Standard CAN/CSA-Z243.100. This Standard defines the services for interlibrary loan. These services are provided by the use of the ILL protocol in conjunction with supporting telecommunications services. This Standard does not specify…

Establishes these values for nuts, with a self-locking feature achieved by forming the upper portion of the nut element out-of-round, having these classifications and into which a sealing ring is incorporated to stop leakage past the threads. Is intended solely for the drawing up of complete product standards.

The volatile bases are distilled in alkaline medium under specified conditions and collected in a known volume of a standard volumetric hydrochloric acid solution in the presence of an indicator. The excess of the acid is titrated with a standard volumetric sodium hydroxide solution.

This standard is applicable to the calculation of short-circuit currents: -in low-voltage three-phase a.c. systems, -in high-voltage three-phase a.c. systems with nominal voltages up to 230 kV operating at nominal frequency (50 Hz or 60 Hz). This standardized procedure is given in such a form as to facilitate as far as possible its use by non-specialist engineers.