Wheelchairs — Part 13: Determination of coefficient of friction of test surfaces
The test method consists in drawing a given block with definite speed over the test surface of in general rough structure. The bottom side of the block is covered with a layer of standard rubber to get comparable results.
Rubber- or plastics-coated fabrics — Standard atmospheres for conditioning and testing
Specifies the requirements and definitions and determines pre-conditioning, characteristics of test atmospheres and methods of conditioning. Technical revision of the clauses 3 and 4 of the first edition (ISO 2231-1973).
Implants for surgery — Partial and total hip joint prostheses — Part 4: Determination of endurance p...
This standard defines a test method and laboratory conditions so that the important parameters that affect the components are taken into account and describes how the specimen is set up for testing. The test method has been developed for prostheses that have a plane of symmetry and may not be suitable for other designs. The standard does not cover methods of examining and reporting of the test…
Electric resistance and induction welded steel tubes for pressure purposes — Ultrasonic testing of t...
Two different acceptance levels are considered in table 1. The choice between these acceptance levels will depend on the intended application. Specifies general requirements, method of test, reference standards, reference notches, equipment calibration and checking, acceptance and test report.
Seamless and welded (except submerged arc-welded) steel tubes for pressure purposes — Full periphera...
Is applicable to the inspection of tubes with an outside diameter greater than or equal to 9 mm, and with an outside diameter-to-thickness ratio greater than or equal to 5. Specifies general requirements, method of test, reference standards, reference notch, equipment calibration and checking, acceptance and test report. Annex A contains information concerning testing of tubes having an outside…
Hot-rolled steel sections — Part 1: Equal-leg angles — Dimensions
This first edition as an International Standard constitues a technical revision of ISO Recommendation R 657-1:1968. ISO 657 consists of 21 parts integrating any shapes of sections. ISO 657-1 specifies dimensions of hot-rolled equal-leg angles.
This Technical report of type 2 gives a survey of a designation system for steel selected for use in International Standards. This survey is intended as a base for further unification.
Seamless steel tubes for pressure purposes — Full peripheral magnetic transducer/flux leakage testin...
Applicable to the inspection of tubes with an outside diameter greater than or equal to 9 mm. Specifies general requirements, method of test, reference standards, reference notches, equipment calibration and checking, acceptance and test report. Annex A gives notes on limitations of the magnetic transducer/flux leakage technique.
Mannequins Tailles Canada Standard pour vêtements de filles et garçons,
tailles courantes - dimensi...
S'applique aux dimensions considérées essentielles pour la
fabrication de mannequins utilisés pour évaluer l'ajustement de
vêtements destinés aux filles (Tailles Canada Standard, tailles
courantes pour filles 3, 4, 6 et 10) et aux garçons (Tailles
Canada Standard, tailles courantes pour garçons 3, 4, 6 et 10).
Les dimensions de trois types de mannequins (types A, B et C)
sont données.
Information Processing Systems - Open Systems Interconnection - Service Definition for the Associati...
This National Standard of Canada is equivalent to International Standard ISO 8649-1988.
It defines ACSE services for application-association control in an open systems interconnection environment.
The ACSE services are provided by the use of the ACSE protocol (ISO 8650) in conjunction with the presentation-service (ISO 8822).
The ACSE services assume as a minimum the use of the…
