Rechercher

Gives methods of test to demonstrate compliance with the general requirements of Part 1 and the specific requirements of Part 3 of the standard.

Specifies requirements for loomstate, continuous filament tapes woven on conventional or shuttleless looms from either glass fibres or a combination of glass and polyester fibres. The ranges of nominal sizes covered by this standard are: width: 10 mm to 50 mm, thickness: 0,05 mm to 0,40 mm.

1. Scope A220.0 1.1 This Standard applies to concrete roof tiles and tiling accessories for use as weather-resistant roofing materials. 1.2 This Standard covers the requirements and procedures for the sampl ing and testing of concrete roof tiles for dimensional requirements, water absorption, water permeability, freezing and thawing resistance, transverse strength, and material…

Provides the minimum requirements for certification of the initial and continuing suitability of a manufacturer's personnel, facilities, and procedures to manufacture concrete roof tiles and roof tiling accessories to meet the requirements of CSA Standard CAN/CSA-A220.0.

Applies to factory-made unitary heat pumps, single-package, or matched assemblies of the type classified in Clause 1.4 intended for application in residential, commercial, and industrial heating and cooling systems.

This National Standard of Canada is equivalent to International Standard ISO 9001-1987. It specifies quality system requirements for use where a contract between two parties requires the demonstration of a supplier's capability to design and supply a product.

This National Standard of Canada is equivalent to International Standard ISO 9002-1987. It specifies quality system requirements for use where a contract between two parties requires demonstration of a supplier's capability to control the processes that determine the acceptability of product supplied.

This National Standard of Canada is equivalent to International Standard ISO 9003-1987. It specifies quality system requirements for use where a contract between two parties requires demonstration of a supplier's capability to detect and control the disposition of any product nonconformity during final inspection and test.

1.1 These requirements apply to the installation of alarm protection products and devices connected to form a residential burglar alarm system. 1.2 These requirements include the criteria for classifying the level of protection at an individual residence. Refer to Appendix A.