Performance Testing of Solid-Fuel-Burning Stoves, Inserts, and
Low-Burn-Rate Factory-Built Firepla...
1. Scope
1.1
This Standard specifies requirements for the performance testing of
solid-fuel-burning appliances having an air-fuel ratio averaging less than 35:1
as determined by Clause 14. It prescribes a method for determining heat
outputs, appliance efficiencies, emission levels and composition, and flue gas
flow rates for solid-fuel-fired appliances. The Standard also specifies…
1.1 General
1.1.1
Applies to occupational diving operations conducted in connection with all
types of work and employment, and describes the requirements for occupational
safety.
Note: It is recognized that certain underwater tasks may require specialized
standards of practice and/or operational techniques which differ from the
requirements of this Standard yet may be acceptable to the…
1.1
Outlines the details of construction, marking, and testing of portable
electrical instruments for sensing the presence of toxic gas(es) and/or oxygen
concentrations in air. These instruments may be used in Class I hazardous
locations and gaseous mines in accordance with the Rules of the Canadian
Electrical Codes, Parts I and II.
1.2
This Standard applies to battery-operated…
Performance and Compatibility Requirements for Telephone Sets
1.1 Purpose
This Standard provides performance and compatibility requirements for telephone
sets intended for direct tip and ring connection to Central Office (CO) or
Private Branch Exchange (PBX) lines. The requirements are based on present
telecommunications plant characteristics at the telephone set interface. These
requirements should ensure satisfactory voice-grade service to the…
Polybutylene (PB) Piping for Pressure Applications
1.1
This Standard covers polybutylene (PB) pipe, tubing, and fittings. Nominal
pipe sizes (NPS) covered are from NPS-1/4 through NPS-2.
Fittings covered include insert-type fittings, socket fusion fittings,
plastic-to-metal transition fittings, and compression-type fittings.
These pipes, tubing, and fittings are intended for use in pressure applications
such as hot and cold potable and…
Seven-Pin Electrical Connector and Cable for Agricultural Towing/Towed
Equipment
1.1
Specifies the physical dimensions and minimum design requirements of the
electrical cable plug and receptacle conforming to SAE Standard J560b, to
achieve interchangeability with electrical connectors of different manufacture.
1.2
These connectors are used with cable described in SAE Standard J1067 and wired
for service as shown in Table 1 (as per ASAE Standard S279.9).
1.3
The location…
Propane Fuel System Components for Use on Highway Vehicles
1.1.1 This Standard applies to the construction and performance of new propane
fuel system components providing motive power of highway vehicles utilizing
internal combustion engines.
1.1.2 This Standard does not apply to stationary or non-highway applications.
1.1.3 This Standard does not apply to propane fuel system components
incorporated during the manufacture of motor vehicles…
Hot Dip Galvanizing of Irregularly Shaped Articles
1.1
Specifies the requirements for zinc coating (galvanizing) by the hot-dipping
process on iron and steel products made from rolled, pressed, or forged shapes
such as structural sections, plates, bars, pipes, or sheets 1 mm thick and
thicker.
1.2
This Standard applies to both unfabricated and fabricated products such as
assembled steel products, structural steel fabrications, large…
This standard applies to fully wax or resin impregnated, water resistant,
corrugated fibreboard boxes for use as interior or exterior shipping containers
for domestic or overseas shipment of supplies.
This standard applies to products of corrugated fibreboard primarily for use as
interior fittings in corrugated fibreboard boxes. Fibreboard boxes are covered
by CAN/CGSB-43.21.