Rechercher

This Recommendation | International Standard defines an Application Service Element (the Common Management Information Service Element), which may be used by an application process in a centralized or decentralized management environment to exchange information and commands for the purpose of systems management, as defined by the OSI Management Framework in CCITT Rec. X.700 | ISO/IEC 7498-4. This…

This Recommendation | International Standard specifies a protocol which is used by application layer entities to exchange management information. This Recommendation | International Standard specifies: ? procedures for the transmission of management information between application entities; ? the abstract syntax of the Common Management Information Protocol (CMIP) and the associated encoding…

Deals with the safety of electric toilets in which excrement is stored, dried or destructed. Electric toilets may be used to process garbage such as paper and food waste. The standard also applies to electric equipment for use with conventional toilets. Examples are pumping units, chopping units, heated seats and automatic seat covering devices.

The purpose of this guide is to find a way to overcome the lack of consistency and unnecessary discrepancies between standards within one system. Furthermore, the cost of over-standardization of one component when the nearest linked component is under-standardized must be considered. The supplementary cost does not in any way increase the reliability of the system as a whole. Since the same…

Is a functional profile (FP) and defines the provision of the TASE.2 communications services between two control centre end systems. This FP also defines the provision of the OSI connection-mode presentation and session services between the end systems. This publication is of high relevance for Smart Grid.

Is applicable to two-pole voltage detectors to be used on electrical systems for nominal voltages not exceeding 1 000 V a.c. and/or 1500 V d.c and below 500 Hz (nominal frequencies). The detector types are classified as follows: voltage class A: up to and including 500 V a.c./750 V d.c.; voltage class B: up to and including 1 000 V a.c./ 1 500 V d.c. Low-voltage detectors covered by this…

Applies to the following main measuring methods: automatic null balance, thermomagnetic or mangetic wind and differential pressure or "Quinke". Deals with ancillary units and applies to analyzers installed both indoors and outdoors. Indends to specify terminology and definitions, unify methods, specify tests and provide basic documents to support the application of standards of quality…

This International Standard presents general terms and definitions relevant to the field of spherical plain bearings. It deals with bearings, bearing parts and features, movements, angles and rod ends. NOTE — In addition to terms and definitions used in the three official ISO languages (English, French and Russian), this International Standard givesthe equivalent terms and definitions in the…

1. Scope 1.1 Purpose The purpose of the Guide is to provide a clear understanding of the requirements of ISO 14001, so that organizations can design, implement, and audit environmental management systems on a consistent basis. The Guide is primarily intended for the use of experienced registrars and auditors engaged in EMS audits for the purposes of registration, self-declaration, or…