Rechercher

IEC 61010-2-034:2023 EXV contains both the international standard and its extended version (EXV). This extended version of the official IEC Standard is available in English only and provides the user with the comprehensive content of the Standard. IEC 61010-2-034:2023 EXV includes the content of the references made to IEC 61010-1:2010 and IEC 61010-1:2010/AMD1:2016. IEC 61010-2-034:2023…

IEC TS 62786-41:2023 (E), which is a Technical Specification, defines minimum requirements for frequency and rate of change of frequency measurements used to control distributed energy resources (DER) and loads connected to electrical power networks. This document specifies the characteristics of frequency and rate of change of frequency measurements to evaluate their performances. It describes…

This document specifies guidelines for the representation and visualization of smart cities. This document: describes the concepts of a smart city, smart city object and smart city data, describes categories of data associated with smart cities,provides guidance for representation of smart cities, describes guidance for visualization of smart cities, provides guidance in selecting the…

This document specifies guidelines for the representation and visualization of smart cities. This document: describes the concepts of a smart city, smart city object and smart city data, describes categories of data associated with smart cities,provides guidance for representation of smart cities, describes guidance for visualization of smart cities, provides guidance in selecting the…

IEC 63241-2-6:2023 supplements or modifies the corresponding clauses in IEC 63241-1, so as to convert it into the IEC Standard: Electric motor-operated tools – Dust measurement procedure – Particular requirements for hand-held hammers. Where a particular subclause of IEC 63241-1 is not mentioned in this document, that subclause applies as far as reasonable. Where this document states "…

This document establishes formulae for the calculation of power rating and centre distance of standard synchronous belts on two pulley drives. It is applicable to trapezoidal belts only. It does not apply to curvilinear synchronous belts. The numerical values of certain parameters used in the calculations depend upon the pitch and the construction of the belt and are specified by the belt…

This document applies to electric and electronic systems and components for vehicles including electric propulsion systems and components with maximum working voltages according to voltage class B. It describes the potential environmental stresses and specifies tests and requirements recommended for the specific mounting location on/in the vehicle. This document describes chemical loads. This…

This document specifies the requirements for periodic inspection and testing to verify the integrity for further service of hoop-wrapped and fully-wrapped composite transportable gas cylinders and tubes, with aluminium-alloy, steel or non-metallic liners or of linerless construction (Types 2, 3, 4, and 5), intended for compressed, liquefied or dissolved gases under pressure, of water capacity…

This document specifies a method for estimating the loudness and loudness level of both stationary and time-varying sounds as perceived by otologically normal adult listeners under specific listening conditions. The sounds may be recorded using a single microphone, using a head and torso simulator, or, for sounds presented via earphones, the electrical signal delivered to the earphones may be…

This document specifies requirements and gives recommendations on the integrity assessment of pipelines of various applications as part of pipeline systems. This document is mainly applicable to onshore pipeline systems, connecting wells, production plants, process plants, refineries and storage facilities, including any section of a pipeline constructed within the boundaries of such facilities…