High-voltage test techniques - Part 3: Definitions and requirements for on-site testing
Applicable to the following on-site test voltages and in service stresses, which are in relation to IEC 60060-1: direct voltage;alternating voltage; lightning impulse voltage of aperiodic or oscillating shape: switching impulse voltage of aperiodic or oscillating shape.
Indoor air — Part 10: Determination of the emission of volatile organic compounds from building prod...
ISO 16000-10:2006 specifies a general laboratory test method for determination of the area specific emission rate of volatile organic compounds (VOCs) from newly produced building products or furnishing under defined climate conditions. The method can also, in principle, be applied to aged products. The emission data obtained can be used to calculate concentrations in a model room.
According to…
Corrosion of metals and alloys — Corrosion and fouling in industrial cooling water systems — Part 2...
ISO 16784-2:2006 applies to corrosion and fouling in industrial cooling water systems
ISO 16784-2:2006 describes a method for preliminary evaluation of the performance of treatment programmes for open recirculating cooling water systems. It is based primarily on laboratory testing but the heat exchanger testing facility can also be used for on-site evaluation. ISO 16784-2:2006 does not include…
Quality requirements for fusion welding of metallic materials — Part 1: Criteria for the selection o...
ISO 3834-1:2005 provides criteria to be taken into account for the selection of the appropriate level of quality requirements for fusion welding of metallic materials, among the three levels specified in ISO 3834-2:2005 ISO 3834-3:2005 and ISO 3834-4:2005. It applies to manufacturing, both in workshops and at field installation sites.
ISO 3834-1:2005 does not specify requirements for a total…
Motorcycles — Test and analysis procedures for research evaluation of rider crash protective devices...
ISO 13232-6:2005 specifies minimum requirements for:
paired comparison tests;the preparation of the dummy, motorcycle and opposing vehicle;the repeatability and reproducibility of impact test conditions within and between test sites;the minimization of variation in secondary test variables;realistic and representative impact conditions for full-scale impact tests; anda means to verify analytical…
Petroleum and natural gas industries — Specific requirements for offshore structures — Part 7: Stati...
ISO 19901-7:2005 specifies methodologies for a) the design, analysis and evaluation of stationkeeping systems for floating structures used by the oil and gas industries to support production, storage, drilling, well intervention and production, production and storage, drilling, well intervention, production and storage, and b) the assessment of stationkeeping systems for site-specific…
1. Scope
1.1
This Standard covers commercial, freestanding, under-counter, and counter-insert dishwashers,utensil-washers, and glass washers using water as the principal cleaning medium, hereafter referred to as dishwashers. These dishwashers utilize steam, gas, or electric heaters for heating water. Heated water is provided to a dishwasher by means of steam, gas, or electric heating systems…
