Rechercher

ISO 18589-2:2015 specifies the general requirements, based on ISO 11074 and ISO/IEC 17025, for all steps in the planning (desk study and area reconnaissance) of the sampling and the preparation of samples for testing. It includes the selection of the sampling strategy, the outline of the sampling plan, the presentation of general sampling methods and equipment, as well as the methodology of the…

This part of IEC 61980 applies to the equipment for the wireless transfer of electric power from the supply network to electric road vehicles for purposes of supplying electric energy to the RESS (Rechargeable energy storage system) and/or other on-board electrical systems in an operational state when connected to the supply network, at standard supply voltages ratings per IEC 60038 up to 1…

This part of ISO 18134 describes the method of determining the total moisture content of a test sample of solid biofuels by drying in an oven and may be used when the highest precision is not needed, e.g. for routine production control on site. The method described in this International Standard is applicable to all solid biofuels. The moisture content of solid biofuels (as received) is always…

1.1 General This Standard specifies requirements for workplace electrical safety necessary for the practical safeguarding of workers during activities such as the installation, inspection, operation, maintenance, and demolition of electric conductors and electric equipment, as well as work in proximity of energized electrical equipment. 1.2 Application While it can be applied by…

1 SCOPE 1.1 This Standard provides the physical property requirements and test methods to determine the material properties for medium density closed cell spray-applied rigid polyurethane foam, used for thermal insulation or for other purposes in building and non-building applications in both site-built construction and prefabrication (manufacturing) facilities. 1.2 The spray polyurethane…

1 Scope and application 1.1 Scope This Standard specifies provisions for the planning, design, and maintenance of surface drainage systems within northern community boundaries. Provisions for drainage outside the community boundary are not covered by this Standard. Note: Specific resources and expertise are required to address drainage provisions outside the community boundary. These resources…

CISPR 16-1-5:2014 specifies the requirements for calibration sites in the frequency range 5 MHz to 18 GHz used to perform antenna calibrations according to CISPR 16-1-6. It also specifies the requirements for reference test sites that are used for the validation of compliance test sites in the frequency range 30 MHz to 1 000 MHz according to CISPR 16-1-4. It has the status of a basic EMC standard…

1 Scope 1.1 Mitigation techniques and other actions This Standard covers the following mitigation techniques to maintain permafrost or remediate permafrost degradation around existing buildings or structures: a) site techniques that consist of i) shading; ii) drainage and grading; and iii) ground cover and snow management; b) foundation techniques that consist of i) ventilation; ii)…

1 Scope 1.1 This Standard deals with over-the-shoe toe protectors for temporary use and includes requirements for one grade of toe impact resistance. Note: This type of protector should not be confused with fully-integrated safety footwear (as specified in CSA Z195). 1.2 This Standard also provides requirements for slip-resisting over-the-shoe toe protectors. 1.3 For the purpose of this…

1.1 This Standard applies to mineral fibre thermal insulation manufactured in the form of faced and unfaced batts, rolls and boards. Where facings are used, they shall be either permeable or vapour retarding membranes, as defined in TABLE 1 for Types 2 and 3, respectively. This standard does not permit the application of kraft paper facings on batts and rolls. It also applies to loose fill…