Rechercher

IEC 60364-7-7-704:2017 lays down requirements which apply to installations for construction and demolition sites for use during the period of the construction or demolition work which are intended to be taken out of service upon completion of the works. Examples include the following: - construction work of new buildings; - repair, alteration, extension or demolition of existing buildings or…

ISO 9349:2017 specifies the requirements and test methods applicable to preinsulated ductile iron pipes, fittings, accessories and their joints for the construction of pipelines (or parts thereof): - to convey water (e.g. potable water), wastewater and other liquids; - to be operated with or without pressure; - to be installed below or above ground; - to limit temperature…

IEC 61400-12-1:2017 RLV contains both the official IEC International Standard and its Redline version. The Redline version is available in English only and provides you with a quick and easy way to compare all the changes between the official IEC Standard and its previous edition. IEC 61400-12-1:2017 specifies a procedure for measuring the power performance characteristics of a single wind…

IEC 61400-12-1:2017 specifies a procedure for measuring the power performance characteristics of a single wind turbine and applies to the testing of wind turbines of all types and sizes connected to the electrical power network. In addition, this standard describes a procedure to be used to determine the power performance characteristics of small wind turbines (as defined in IEC 61400-2) when…

ISO 8503-5:2017 describes a field method for measuring the surface profile produced by any of the abrasive blast-cleaning procedures given in ISO 8504-2. The method uses replica tape and a suitable gauge for measuring, on site, the roughness of a surface before the application of paint or another protective coating. The method is applicable within the range of profile heights cited for a given…

1.1 General This Standard establishes the principles and practices of an environmental compliance audit. It is intended to provide a consistent framework and minimum requirements for conducting ECAs to ensure that the ECAs address regulatory, as well as site-specific requirements. 1.2 Application This Standard may be applied to any organization, its sites or operations, or processes or parts…

ISO 19204:2017 describes in a general way the application of the soil quality TRIAD approach for the site-specific ecological risk assessment of contaminated soils. In detail, it presents in a transparent way three lines of evidence (chemistry, ecotoxicology and ecology) which together allow an efficient, ecologically robust but also practical risk assessment of contaminated soils. This procedure…

1.1 Facilities 1.1.1 Types of facilities 1.1.1.1 This Standard addresses the establishment and implementation of ALs for Class I nuclear facilities and uranium mines and mills. Notes: 1) In this Standard, any type of Class I nuclear facility or uranium mine and mill is included in the term “nuclear facilities”. 2) Conventional waste management facilities (e.g., landfills, incinerators,…

1.1 Facilities and workplaces impacted This Standard identifies the requirements for a PSM system for facilities and worksites handling or storing materials that are potentially hazardous, either due to an inherent chemical, biological, toxicological, or physical property of those materials, or due to the material’s potential or kinetic energy 1.2 Minimum lifecycle requirements This Standard…

ISO 18400-204:2017 contains guidance on soil gas sampling using - active sampling (adsorbents, filters, air containers), and - passive sampling applied at permanent or temporary monitoring wells or other installations in soils or underneath buildings (sub-slab). It provides guidance on: - development of a sampling plan; - construction of monitoring installations; -…