Rechercher

This document specifies requirements for 14 grades of high-carbon cast-steel shot and 11 grades of high-carbon cast-steel grit, as supplied for blast-cleaning processes. Values are specified for hardness, density, defect/structural requirements and chemical composition. The requirements specified in this document apply to abrasives supplied in the "new" condition only. They do not apply…

1 Scope 1.1 This Standard a) provides minimum requirements, guidance, and best practices for land use planning and development processes in the vicinity of existing pipeline systems; b) addresses roles, responsibilities, and engagement of all stakeholders to establish a consistent approach to land use planning in the vicinity of existing pipeline systems; and c) focuses on long-range…

This document, in conjunction with ISO 11297‑1, specifies requirements and test methods for close-fit lining systems intended to be used for the renovation of underground drainage and sewerage networks under pressure. It applies to pipes and fittings, as manufactured, as well as to the installed lining system. It is applicable to polyethylene (PE) pipes of either solid wall single layer or co-…

This document, in conjunction with ISO 11298‑1, specifies requirements and test methods for close-fit lining systems intended to be used for the renovation of water supply networks, which transport water intended for human consumption, including raw water intake pipelines. It applies to pipes and fittings, as manufactured, as well as to the installed lining system. It is applicable to…

This document defines the safety programme and the technical safety requirements that are implemented in order to comply with the safety policy as defined in ISO 14300‑2. It is intended to protect flight and ground personnel, the launch vehicle, associated payloads, ground support equipment, the general public, public and private property, and the environment from hazards associated with space…

This document specifies requirements for 12 grades of low-carbon cast-steel shot abrasive, as supplied for blast-cleaning processes. Values are specified for hardness, density, defect/structural requirements and chemical composition. The requirements specified in this document apply to abrasives supplied in the "new" condition only. They do not apply to abrasives either during or after…

This document specifies requirements for 12 grades of chilled-iron grit abrasives, as supplied for blast-cleaning processes. It specifies ranges of particle sizes, together with corresponding grade designations. Values are specified for hardness, density, defect/structural requirements and chemical composition. The requirements specified in this document apply to abrasives supplied in the "…

This document specifies general requirements and test methods for catheter systems intended to be used in neuraxial applications. This document specifies requirements for intended performance, design attributes, materials, design evaluation, manufacture, sterilization, packaging and information supplied by the manufacturer, and tests to demonstrate conformity with these requirements. Catheters…

This document addresses human exposure to multiple mechanical shocks, and it formulates requirements for the measurement of multiple shocks. The results of these measurements are then analyzed to provide information for the assessment of the risk of adverse health effects to the vertebral end-plates of the lumbar spine for seated individuals due to compression. Other injuries could develop even…

This document is applicable to cookstoves used primarily for cooking or water heating in domestic, small-scale enterprise, and institutional applications, typically with firepower less than 20 kW and cooking vessel volume less than 150 l, excluding cookstoves used primarily for space heating. For solar cookstoves, the provisions of this document are applicable only for evaluating cooking power,…