Basic environmental testing procedures - Part 2-39: Tests - Test Z/AMD: Combined sequential cold, lo...
Applies to aircraft components and equipment, particularly to those installed in unheated or unpressurized conditions.
Has the status of a basic safety publication in accordance with IEC Guide 104.
Essais fondamentaux climatiques et de robustesse mécanique - Partie 2-39: Essais - Essai Z/AMD: Essa...
Essai destiné aux composants et équipements utilisés dans l'aéronautique, en particulier dans les parties non chauffées et non pressurisées.
A le statut d'une publication fondamentale de sécurité, conformément au Guide CEI 104.
Connectors for frequencies below 3 MHz. Part 8: Concentric connectors for audio circuits in radio re...
Describes two jack sockets for 3.50 to 3.60 mm (0.138 to 0.142 in) and 2.44 to 2.49 mm (0.096 to 0.098 in) jack plugs (these are the minimum and maximum dimensions respectively of the two male gauges described in the publication).
Connecteurs utilisés aux fréquences jusqu'à 3 MHz. Huitième partie: Connecteurs concentriques p...
Concerne deux embases femelles acceptant des jacks de 3,50 mm à 3,60 mm (0,138 à 0,142 in) et de 2,44 mm à 2,49 mm (0,096 à 0,098 in). (Ces cotes sont respectivement les valeurs minimales et maximales des deux calibres mâles figurant dans la publication.)
Road vehicles — Frontal fixed barrier collision test method
Specifies a test method which should ensure that results obtained from different test facilities are directly comparable. Includes definitions; describes the impact test facilities, the state of the vehicle, the velocity to be used. The instrumentation will be given in an other ISO publication.
Recommended Practices for Ultrasonic Inspection of Structural Welds
1. SCOPE
1.1 This publication provides instructions for the ultrasonic inspection of
butt joints in material over 6 mm (0.2 inch) thichness, and in tee and corner
joints where suitable testing procedures can be established. It also provides
an outline of minimum equipment requirements, methods of calibrating the
equipment, and technical information on ultrasonics.
1.2 The two…
Copper alloys — Determination of aluminium as alloying element — Volumetric method
This method is applicable to all types of copper alloys listed in ISO publications. This method determines aluminium by chelatometric titration at a pH value of about 6, following a sodium fluoride demasking procedure, and using a voltametric indication. ISO 3110 specifies principle, reagents, apparatus, sampling, procedure, expression of results and test report.
