Rechercher

Sets out the general requirements for the operation of a system for accreditation of calibration and/or testing laboratories so that the accreditations granted and the services covered by the accreditations may be recognized at a national or an international level and the body operating the accreditation system may be recognized at national or international level as competent and reliable. The…

This National Standard of Canada is based on International Standard IEC 1010-1:1990. 1.1 Scope This International Standard specifies general safety requirements for electrical equipment intended for professional, industrial process, and educational use, including equipment and computing devices for: - measurement and test; - control; - laboratory use; - accessories intended for use with…

1.1 This Standard applies to medical gas piping systems for conducting nonflammable medical gases used for patient care in health care facilities. Included in this Standard are requirements pertaining to small systems such as those serving dental suites, as well as systems providing nonflammable medical gases to laboratories. Notes: (1) The manufacture, control, and distribution of…

1.1 This Standard provides guidance for the safe use of medically applied laser systems, hereinafter referred to as medical lasers, for diagnostic, therapeutic, and medical research purposes in health care facilities. It is intended for use by all persons associated with the administration, installation, operation, maintenance, and service of medical lasers. 1.2 This Standard presents…

Applies to: testing laboratories, including those providing a calibration service; suppliers of products or services; other organizations where measurement is used to demonstrate compliance with specified requirements.

The conformance test suites based on this part are designed for use by: test laboratories which provide a conforming testing service for the ACSE protocol; test realizers; implementors of the ACSE protocol. Annexes A and B are for information only.

The conformance test suites based on this part are designed for use by: test laboratories which provide a conforming testing service for the ACSE protocol; test realizers; implementors of the ACSE protocol. Annexes A and B are for information only.

1.1 La présente norme définit les exigences relatives à l'équipment, les critères de rendement, la procédure à suivre et les méthodes d'essai pour la mise en place des systèmes de récupération des vapeurs (SRV) dans les réseaux de distribution de l'essence comprenant les terminaux, les dépôts routiers, les stations-service et les camions-citernes qui sont regroupés dans la…

1.1 This standard defines equipment requirements, performance criteria, operating and testing procedures for the implementation of Vapour Control Systems (VCS) in gasoline distribution networks including terminals, bulk plants, service stations and cargo tanks, commonly known as Stage I. (See Figure I for schematic representation.) 1.1.1 This standard does not include vapour control…

Describes conditions under which adhesive joints may be exposed to various climatic or chemical influences for the purpose of assessing the effects of such influences on certain properties. They are not necessarily applicable to the determination of the service life of a bonded assembly. The principle consists in defining the ageing conditions that relate most closely to the application for the…