Rechercher

ISO 24534-3:2010 provides requirements for electronic registration identification (ERI) that are based on an identifier assigned to a vehicle (e.g. for recognition by national authorities) suitable to be used for: electronic identification of local and foreign vehicles by national authorities; vehicle manufacturing, in-life maintenance and end-of-life identification (vehicle life cycle…

La CEI 61010-1:2010 spécifie les exigences générales de sécurité pour les types suivants d'appareils électriques et leurs accessoires où qu'ils soient destinés à être utilisés. a) Appareils électriques d'essai et de mesurage b) Appareils électriques de contrôle de procédés industriels c) Appareils électriques de laboratoire Cette troisième édition annule et remplace la seconde…

ISO/TS 14907-1:2010 specifies the test procedures of EFC road-side equipment (RSE) and on-board equipment (OBE) with regard to the conformance to standards and requirements for type approval and acceptance testing which is within the realm of EFC application specifically. ISO/TS 14907-1:2010 is restricted to systems operating within the radio emission, EMC regulations, traffic and other…

Scope 1.1 Facilities 1.1.1 Types of facilities 1.1.1.1 This Standard addresses the design and operation of EMPs for Class I nuclear facilities and uranium mines and mills. These facilities include (a) nuclear reactors; (b) uranium mines, mills, refineries, and conversion plants; (c) uranium fuel fabrication plants; (d) isotope-processing facilities; (e) particle accelerators; and…

Scope 1.1 This Standard specifies the test methods and marking requirements, and references energy efficiency levels for three-phase induction motors. Note: The test methods contained in this Standard are not limited to specific types of motors, but where this Standard is referenced in regional legislation, some specific motor types might be included or excluded from the regulations.…

Scope 1.1 This Standard provides management requirements for facilities that collect, process, store, and use human blood and blood components for transfusion. It addresses issues of safety, efficacy, and quality for recipients, safety of donors, management of blood and blood components, and safety of facility personnel and others who are exposed to or potentially affected by blood and blood…

Scope 1.1 This Standard specifies procedures for 24 h simulated-use testing of gas-fired instantaneous water heaters. This Standard also provides calculations for the determination of (a) the maximum L/min (gpm) rating; (b) recovery efficiency (thermal efficiency); (c) daily water-heating energy consumption; (d) energy factor; and (e) annual energy consumption. 1.2 This Standard applies to gas-…

Preface This is the first edition of CSA Z314.10.1, Selection and use of gowns, drapes, and wrappers in health care facilities. Together with CSA Z314.10.2, it supersedes the previous editions of CAN/CSA-Z314.10, which was published in 2003 under the title Selection, Use, Maintenance, and Laundering of Reusable Textile Wrappers, Surgical Gowns, and Drapes for Health Care Facilities, and…

Scope 1.1 This Standard applies to control and protective devices, and accessory devices, rated at not more than 1500 V, for starting, stopping, regulating, controlling, or protecting electric motors, generators, heating apparatus, or other equipment used to control an industrial process that is intended to be installed and used in non-hazardous locations in accordance with the rules of the…

Scope 1.1 This Code applies to the installation, servicing, and repair of propane fuel system components and tanks on highway vehicles for the provision of motive power. This does not apply to vehicles qualified under the Canadian Motor Vehicle Safety Regulations. 1.2 Where the term "propane" is used, the requirements of this Code include, and apply equally to, any material that is…