Rechercher

1.1 Statement of scope The modelling of a business transaction through scenarios and scenario components is done by specifying the applicable constraints through explicitly stated rules. The Open-edi Reference Model identified two basic classes of constraints, namely “internal constraints” and “external constraints” (see further Annex G). ISO/IEC 15944-4 focuses on internal constraints with a…

1 Scope 1.1 Mitigation techniques and other actions This Standard covers the following mitigation techniques to maintain permafrost or remediate permafrost degradation around existing buildings or structures: a) site techniques that consist of i) shading; ii) drainage and grading; and iii) ground cover and snow management; b) foundation techniques that consist of i) ventilation; ii)…

This Standard applies to unvented portable type gas camp heaters of the catalytic and infrared type only up to and including a maximum input of 12,000 Btu/hr (3 517 w) using propane, butane, and liquefied petroleum gas mixtures thereof, and intended for outdoor use. 1.2 This Standard applies to portable type gas camp heaters having a: a) regulated pressure; or b) non-regulated pressure. 1.…

ISO 6460-2:2014 defines test cycles for measurement for the gaseous exhaust emissions from motorcycles, as well as for determining the fuel consumption of motorcycles as defined in ISO 3833, equipped with a spark ignition engine (four-stroke engine, two-stroke engine, or rotary piston engine) or a compression ignition engine. The test cycle 1 is equivalent to the test cycle specified in the…

1 Scope 1.1 This Standard applies to portable type gas water heaters (herein after referred to as appliance or water heater) for use with propane, butane, or liquefied petroleum gases and mixtures thereof having: a) a regulated pressure; b) a non-regulated pressure. 1.2 Portable type water heaters and components employing materials or having forms of construction differing from those…

1 SCOPE 1.1 This Standard sets forth minimum design and construction requirements for fibre reinforced plastic, non-pressure tanks that are used for the underground storage of flammable and combustible liquids, such as: A Petroleum products, including petroleum hydrocarbon fuels with low bio-blends, per specifications, and similar flammable or combustible liquid petroleum derivatives, such…

1 SCOPE 1.1 This Standard provides minimum requirements for nonmetallic internal retrofit systems intended for field installation in underground tanks for the storage of flammable and combustible liquids, such as: A Petroleum products, including petroleum hydrocarbon fuels with low bio-blends per specifications and similar flammable or combustible liquid petroleum derivatives, such as fuel…

IEC 61910-1:2014 applies to radiation dose structured reports produced by X ray equipment that falls within the scope of IEC 60601-2-43:2010 or IEC 60601-2-54:2009. This document does not impose specific requirements on the accuracy of the reported or displayed data. Existing standards or regulations can have applicable requirements for accuracy and precision. This standard provides specific…

ISO 18541-1:2014 provides a general overview and structure of each part of ISO 18541. It also specifies use cases related to repair and maintenance information (RMI) systems in order to standardize the access to RMI for independent operators. ISO 18541-1:2014 also describes the use cases applicable to the standardized access to automotive RMI. The use cases address real world scenarios (e.g.…

1 SCOPE 1.1 These requirements cover discrete electrical control units, communication units, transport products which manipulate the data packets, interfaces, and accessories for mass notification systems. 1.2 The products covered by this standard are intended to be used in combination with other appliances and devices to form an emergency communication and/or mass notification system. These…