Rechercher

ISO/IEC 19770-3:2016 establishes a set of terms and definitions which may be used when discussing software entitlements (an important part of software licenses). It also provides specifications for a transport format which enables the digital encapsulation of software entitlements, including associated metrics and their management. This common set of terms and associated transport format is…

ISO 15031-3:2016 references the latest publication of SAE J1962. On-board diagnostic (OBD) regulations require road vehicles to be equipped with a standardized connector for purposes of access to OBD information by ISO 15031‑4 compliant external test equipment. This part of ISO 15031 describes the requirements for the physical connection and associated pin usage to allow for standard access to…

1.1 Inclusions This Standard is intended to be used for compressed air systems with the following characteristics: a) electrically driven three-phase air compressors equal to or greater than 5 horsepower; b) positive displacement stationary air compressors and associated equipment; c) operating pressures between 2.5 and 17 bar(g) (36 and 250 psi(g)); and d) industrial and commercial…

1.1 This Standard applies to all ballasts for high-intensity discharge (HID) and low-pressure sodium (LPS) lamps intended to operate with an input line frequency of 60 Hz. Note: Safety requirements for ballasts are provided in Part 2 of CAN/CSA-C22.2 No. 74. 1.2 This Standard defines the measurement technique for determining the efficiency of HID and LPS lamp ballasts for use in HID and LPS…

1.1 This Standard applies to fuel gas piping systems using corrugated stainless steel tubing (CSST), intended for installation in residential, commercial or industrial buildings, and including the following components as a minimum: a) Corrugated stainless steel tubing (CSST); b) Fittings for connection to the CSST; and c) Striker plates (see Clause 3, Definitions) to protect the installed…

1.1 Organization and content This standard sets out requirements for designing, manufacturing and marking of Intermediate Bulk Containers (IBCs) and for selecting and using means of containment for the transportation of dangerous goods of classes 3, 4, 5, 6.1, 8 and 9. This standard consists of two parts and four annexes. Part I contains the requirements for the design and manufacture of UN…

ISO 24534-3:2016 provides the requirements for an electronic registration identification (ERI) that is based on an identifier assigned to a vehicle (e.g. for recognition by national authorities) suitable to be used for the following: - electronic identification of local and foreign vehicles by national authorities; - vehicle manufacturing, in-life-maintenance, and end-of-life…

ISO 5667-24:2016 provides an audit protocol to monitor conformity with declared, or assumed, practices in all areas of water quality sampling. Specifically, this part of ISO 5667 provides guidance on the systematic assessment of sampling practices and procedures in the field, and assessing conformity with those given in the organization's sampling manual. It is applicable to the audit of…

ISO 27145-4:2016 defines the requirements to successfully establish, maintain and terminate communication with a vehicle that implements the requirements of the WWH-OBD GTR (Global technical regulation No. 5; see Reference [16]). This requires plug and play communication capabilities for the vehicle, as well as for any test equipment that intends to establish communication with a vehicle. This…

ISO 4254-14:2016 intended to be used together with ISO 4254‑1, specifies the safety requirements and their verification for the design and construction of mounted, semi-mounted, trailed, and stationary bale wrapper for bales of agricultural harvesting products including wrappers which are combined or integrated with pick-up balers. It describes methods for the elimination or reduction of hazards…