Rechercher

This standard applies only to MEDICAL ELECTRICAL EQUIPMENT, MEDICAL ELECTRICAL SYSTEMS, INFORMATION TECHNOLOGY EQUIPMENT used in medical electrical application, and all other equipment forming part of MEDICAL ELECTRICAL SYSTEMS, hereinafter referred to as EQUIPMENT and/or SYSTEMS designed to be installed and used in accordance with the rules of the Canadian Electrical Code, Part 1. The…

1.1 General This standard covers materials to be used and methods to be followed for the manufacture, transportation, and erection of architectural, structural, and specialty precast concrete products. Notes: (1) Good control over dimension, appearance, and performance of precast concrete products can be obtained when this Standard is used. (2) This Standard should be specified for…

Scope 1.1 General This Guideline provides a method for conducting environmental life cycle analysis and assessment. It guides industry formulation of product life cycle process stages, stage screening and problem definition, inventory analysis, and evaluation of environmental burdens for possible improvements. This Guideline addresses the life cycle assessment (LCA) components…

1.1 This Standard is intended for the performance rating of factory-assembled unitary heat pumps, that are intended for use in direct-expansion (DX) ground-source heat pump systems. 1.2 Within the scope of the Standard, DX heat pumps are classified as single-package or matching assemblies that utilize indoor air as the energy sink on heating and the energy source on cooling, and a refrigerant as…

1.1 This Standard applies to all types of fume hoods. 1.2 This Standard specifies safety requirements for fume hoods and test methods to be used to determine performance. 1.3 This Standard provides recommendations for selection, use, user education and maintenance of fume hoods. 1.4 This Standard provides recommendations for necessary information to be exchanged between the supplier…

For specific information, see individual standards in the series.

1.1 This Standard applies to the following plumbing fixtures: (a) bathtubs; (b) kitchen and bar sinks; (c) lavatories; (d) laundry tubs; (e) shower enclosures and receptors; (f) drinking fountains and water coolers; (g) water closets; (h) bidets; (i) urinals; (j) non-recirculating toilets and waste-holding tanks for use in recreational vehicles; and (k) self-contained, recirculating…

Establishes how to provide this information when additional information to the designation according to ISO 513 about workpiece materials to be machined, as well as toughness characteristics and performance data of the hard cutting material is considered to be useful.